HP Uninterruaptible Power System R1500 XR Models 217823-002 manual Configuration

Page 25

3

Configuration

This chapter contains information on configuring the UPS. Proper configuration of the UPS is important in performing other functions on the unit, such as maintaining the battery and troubleshooting alarms.

Placing the UPS in Configure Mode

The UPS can enter Configure mode while in Operate or Standby mode.

To place the UPS in Configure mode:

1. Remove the front bezel by snapping the bezel off (1).

1

Figure 3-1: Removing the UPS front bezel

HP Uninterruptible Power System R1500 XR Models User Guide

3-1

Image 25

Contents HP Uninterruptible Power System R1500 XR Models User Guide Page Contents Chapter Troubleshooting Appendix B Electrostatic Discharge Page Symbols on Equipment Important Safety InformationAbout This Guide Audience AssumptionsRack Stability Symbols in TextRelated Documents Reader’s Comments Getting HelpTechnical Support HP Website Authorized ResellerOverview Standard UPS FeaturesCommunications Port Network Transient Protector UPS R1500 XR ModelsOvercurrent Protection UPS R1500 XR ModelsFront Panel Front panel configurationRear panel of R1500 XR NA Rear PanelsRear panel of R1500 XR JPN Rear panel of R1500 XR H INT’L UPS Hardware Options Power Management SoftwareHardware Options Option Part Number$25,000 Computer Load Protection Guarantee Remote Emergency Power Off PortWarranties Pre-Failure Battery Warranty Operation Front Panel Controls and LED IndicatorsDescription Meaning/Function LED Modes of OperationCharging the Batteries Placing the UPS in Operate ModePlacing the UPS in Standby mode Returning to Standby ModeInitiating a Self-Test Test/Alarm Reset buttonSilencing an Audible Alarm Audible AlarmsShutting Down the System Placing the UPS in Configure Mode ConfigurationConfiguration Parameters Configuration ParametersParameter LED Parameter Name Explanation when illuminated Available Voltage Settings Changing Configuration ParametersConfiguration Precautions Battery MaintenanceCharging Batteries Obtaining New Batteries Determining When to Replace BatteriesReplacing Batteries Removing the Battery PackPreparing the UPS Remove the two screws to obtain access to the battery pack Disconnecting the battery cable from the circuit board Testing the New Battery Pack Installing a New Battery PackDisposing of Used Batteries Care and Storage of Batteries Troubleshooting TroubleshootingTroubleshooting Symptom Possible Cause Suggested ActionTroubleshooting Troubleshooting Repairing the UPS Regulatory Compliance Identification Numbers Regulatory Compliance NoticesFederal Communications Commission Notice Class a EquipmentModifications Class B EquipmentEuropean Union Notice Canadian Notice Avis CanadienCables Japanese Notice China Taiwan Notice Battery Replacement Notice Grounding Methods Electrostatic DischargePhysical Specifications SpecificationsTable C-1 Physical Specifications Feature MetricTable C-2 Input Specifications Input SpecificationsTable C-3 Output Specifications Output SpecificationsTable C-4 Output Specifications Environmental Specifications Battery SpecificationsTable C-5 Battery Specifications Table C-6 Environmental SpecificationsIndex Index-2 Index-3