Configuration
2.Press and hold the Configure button (1) for three seconds. When the Configure button is released, the front panel configuration parameters flash in unison and the Configure Mode On LED (2) illuminates solid green.
1 | 2 |
Figure 3-2: Placing the UPS in Configure mode
Configuration Parameters
In Configure mode, the front panel LED display changes function to allow UPS monitoring. The LED control buttons allow modification of the UPS configuration parameters. The configuration parameters are defined in Table
Table 3-1: Configuration Parameters
Parameter (LED) | Parameter Name | Explanation (when illuminated) | ||||||
General Alarm | 100 Nom* | Nominal utility voltage level is selected to 100 VAC. | ||||||
( |
|
| ) |
|
| |||
|
|
|
|
| ||||
On Battery | 110/220 Nom | Nominal utility voltage level is selected to 110/220 VAC. | ||||||
( |
|
|
|
|
| ) |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| ||||
|
|
| ||||||
Bad Battery/Low | 120/230 Nom | Nominal utility voltage level is selected to 120/230 VAC. | ||||||
Battery |
|
| ||||||
( |
|
|
| ) |
|
| ||
|
|
|
|
| ||||
|
|
|
|
| ||||
|
|
| ||||||
Site Wiring Fault | 127/240 Nom | Nominal utility voltage level is selected to 127/240 VAC. | ||||||
Indicator |
|
| ||||||
( |
|
|
| ) |
|
| ||
|
|
| ||||||
Utility LED | Site Wiring | Audible alarm is enabled if ground is missing, or if line | ||||||
( |
|
|
| ) | Fault Indicator | and neutral connections are reversed. | ||
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
*The 200/208 parameter is printed on the front panel for future enhancement purposes.
HP Uninterruptible Power System R1500 XR Models User Guide |