HP Uninterruaptible Power System R1500 XR Models 217823-002 manual Configuration

Page 28

Configuration

2.To advance to the appropriate voltage configuration (to the right), press the On button (3). The selected voltage configuration LED flashes. Activate the voltage configuration by pressing the Standby button (2). The previously selected configuration parameter LED turns off.

NOTE: Only one nominal utility voltage can be configured. When setting voltage configuration parameters, selecting an On value for any one parameter automatically sets the other three possibilities to Off.

3.To toggle the Site Wiring Fault option from active to inactive, press the On button (3) to advance to the Site Wiring Fault LED, then press the Standby button (2).

4.To accept the configuration settings and exit Configure mode, press the Test/Alarm Reset button (1).

NOTE: If the unit remains idle for two minutes, Configure mode times out and the configuration settings are not stored.

3-4	HP Uninterruptible Power System R1500 XR Models User Guide

Image 28

Contents HP Uninterruptible Power System R1500 XR Models User Guide Page Contents Chapter Troubleshooting Appendix B Electrostatic Discharge Page Important Safety Information Symbols on EquipmentAbout This Guide Audience AssumptionsRack Stability Symbols in TextRelated Documents Getting Help Reader’s CommentsTechnical Support HP Website Authorized ResellerOverview Standard UPS FeaturesCommunications Port UPS R1500 XR Models Network Transient ProtectorOvercurrent Protection UPS R1500 XR ModelsFront panel configuration Front PanelRear Panels Rear panel of R1500 XR NARear panel of R1500 XR JPN Rear panel of R1500 XR H INT’L Power Management Software UPS Hardware OptionsHardware Options Option Part Number$25,000 Computer Load Protection Guarantee Remote Emergency Power Off PortWarranties Pre-Failure Battery Warranty Operation Front Panel Controls and LED IndicatorsDescription Meaning/Function Modes of Operation LEDPlacing the UPS in Operate Mode Charging the BatteriesReturning to Standby Mode Placing the UPS in Standby modeTest/Alarm Reset button Initiating a Self-TestSilencing an Audible Alarm Audible AlarmsShutting Down the System Configuration Placing the UPS in Configure ModeConfiguration Parameters Configuration ParametersParameter LED Parameter Name Explanation when illuminated Changing Configuration Parameters Available Voltage SettingsConfiguration Precautions Battery MaintenanceCharging Batteries Determining When to Replace Batteries Obtaining New BatteriesReplacing Batteries Removing the Battery PackPreparing the UPS Remove the two screws to obtain access to the battery pack Disconnecting the battery cable from the circuit board Testing the New Battery Pack Installing a New Battery PackDisposing of Used Batteries Care and Storage of Batteries Troubleshooting TroubleshootingTroubleshooting Symptom Possible Cause Suggested ActionTroubleshooting Troubleshooting Repairing the UPS Regulatory Compliance Notices Regulatory Compliance Identification NumbersFederal Communications Commission Notice Class a EquipmentClass B Equipment ModificationsEuropean Union Notice Canadian Notice Avis CanadienCables Japanese Notice China Taiwan Notice Battery Replacement Notice Electrostatic Discharge Grounding MethodsSpecifications Physical SpecificationsTable C-1 Physical Specifications Feature MetricInput Specifications Table C-2 Input SpecificationsTable C-3 Output Specifications Output SpecificationsTable C-4 Output Specifications Battery Specifications Environmental SpecificationsTable C-5 Battery Specifications Table C-6 Environmental SpecificationsIndex Index-2 Index-3