HP RP5 5810 manual Serial Number Location, 7Cable Routing

Page 12

3.Tighten the two captive screws on the bottom of the port cover to secure it in place. Figure 1-6Securing the Port Cover

4.The port cover is designed to allow cables to route out of the back of the computer horizontally or vertically.

Figure 1-7Cable Routing

Serial Number Location

Each computer has a unique serial number and product ID number located on the back or side of the computer. Keep these numbers available for use when contacting customer service for assistance.

6 Chapter 1 Product Features

Image 12

Contents Hardware Reference Guide Product Notice About This Book Iv About This Book Table of contents Preventing Electrostatic Damage Grounding Methods Product Features Standard Configuration FeaturesDrive configuration may vary by model Front Panel Components Rear Panel Components 2Rear Panel ComponentsChanging from Desktop to Tower Configuration Installing the Optional Port Cover Serial Number Location 7Cable RoutingHardware Upgrades Removing the Computer Access Panel Replacing the Computer Access PanelRemoving the Front Bezel Installing an Optical Drive Bezel 5Installing the Optical Drive Bezel Hardware UpgradesRemoving a Bezel Blank Replacing the Front BezelInstalling Additional Memory DIMMsDDR3-SDRAM DIMMs Populating Dimm Sockets 1DIMM Socket LocationsInstalling DIMMs Page Page Installing a Half-Height Expansion Card 2System Board Expansion Slot LocationsInstalling a 12-Volt Powered USB Expansion Card 1324-volt and 12-volt Powered USB ConnectorsPage Page Page Page Page Installing a Second DisplayPort Expansion Card Page Page Installing a Full-Height Expansion Card 4Riser Card ConfigurationsInstalling a Powered Serial Port Expansion Card 25Powered Serial PortsPage Page Close the expansion card retention latch Configuring Powered Serial Ports Replacing the Riser CardPage 35Removing the Lower Expansion Slot Cover Hardware Upgrades 37Removing the Riser Card Bracket Replacing the Riser Card 39Installing the Riser Card Hardware Upgrades Page Close the expansion card retention latch Installing and Removing Drives Drive Positions45Extra Guide Screw Locations System Board Drive Connections 8System Board Drive ConnectionsRemoving an Optical Drive from the 5.25-inch Drive Bay Page Installing an Optical Drive into the 5.25-inch Drive Bay 50Removing the 5.25-inch DrivePage Page Page Removing a Secondary Hard Drive from the 3.5-inch Drive Bay Page 60Installing a Secondary Hard Drive Hardware Upgrades Page 63Raising the Power Supply Hardware Upgrades Page Page 67Installing the Hard Drive Installing and Removing Drives Page Replacing the Battery Type69Removing and Replacing a Coin Cell Battery Type Installing a Security Lock HP Keyed Cable LockPadlock HP Business PC Security Lock Page Page Page Front Bezel Security Page Optional Integration Tray and Accessories Page Preventing Electrostatic Damage Grounding MethodsComputer Operating Guidelines and Routine Care Optical Drive Precautions CleaningSafety Shipping PreparationIndex USB