HP RP5 5810 manual

Page 29

11.The cable included with the card has a single connector on one end and dual connectors on the other end. Connect the single end of the cable to the rear of the card (1). Connect the green connector on the other end of the cable to the green 12-volt USB connector on the system board

(2). The cable will plug on one side of the green connector only. Connect the black connector to one of the two black 12-volt USB connectors on the system board (3).

NOTE: The system board connectors allow you to install two 12-volt Powered USB expansion cards. The green connectors on the system board are coupled together as one connector. The black connectors on the system board are separate connectors.

Figure 2-18Connecting the 12-volt Powered USB Cable

12.Rotate the slot cover retention latch back in place to secure the expansion card. Figure 2-19Closing the Expansion Card Retention Latch

13.Replace the computer access panel.

14.If the computer was on a stand, replace the stand.

Installing a Half-Height Expansion Card 23

Image 29

Contents Hardware Reference Guide Product Notice About This Book Iv About This Book Table of contents Preventing Electrostatic Damage Grounding Methods Standard Configuration Features Product FeaturesFront Panel Components Drive configuration may vary by model2Rear Panel Components Rear Panel ComponentsChanging from Desktop to Tower Configuration Installing the Optional Port Cover 7Cable Routing Serial Number LocationHardware Upgrades Replacing the Computer Access Panel Removing the Computer Access PanelRemoving the Front Bezel 5Installing the Optical Drive Bezel Hardware Upgrades Installing an Optical Drive BezelReplacing the Front Bezel Removing a Bezel BlankDDR3-SDRAM DIMMs Installing Additional MemoryDIMMs 1DIMM Socket Locations Populating Dimm SocketsInstalling DIMMs Page Page 2System Board Expansion Slot Locations Installing a Half-Height Expansion Card1324-volt and 12-volt Powered USB Connectors Installing a 12-Volt Powered USB Expansion CardPage Page Page Page Page Installing a Second DisplayPort Expansion Card Page Page 4Riser Card Configurations Installing a Full-Height Expansion Card25Powered Serial Ports Installing a Powered Serial Port Expansion CardPage Page Close the expansion card retention latch Replacing the Riser Card Configuring Powered Serial PortsPage 35Removing the Lower Expansion Slot Cover Hardware Upgrades 37Removing the Riser Card Bracket Replacing the Riser Card 39Installing the Riser Card Hardware Upgrades Page Close the expansion card retention latch Drive Positions Installing and Removing Drives45Extra Guide Screw Locations 8System Board Drive Connections System Board Drive ConnectionsRemoving an Optical Drive from the 5.25-inch Drive Bay Page 50Removing the 5.25-inch Drive Installing an Optical Drive into the 5.25-inch Drive BayPage Page Page Removing a Secondary Hard Drive from the 3.5-inch Drive Bay Page 60Installing a Secondary Hard Drive Hardware Upgrades Page 63Raising the Power Supply Hardware Upgrades Page Page 67Installing the Hard Drive Installing and Removing Drives Page Type Replacing the Battery69Removing and Replacing a Coin Cell Battery Type HP Keyed Cable Lock Installing a Security LockPadlock HP Business PC Security Lock Page Page Page Front Bezel Security Page Optional Integration Tray and Accessories Page Grounding Methods Preventing Electrostatic DamageComputer Operating Guidelines and Routine Care Cleaning Optical Drive PrecautionsSafety Shipping PreparationIndex USB