HP RP5 5810 manual

Page 53

11.Connect the power cable (1) and data cable (2) to the rear of the optical drive.

NOTE: The power cable for the optical drive is a three-headed cable that is routed from the system board to the primary hard drive, then to the secondary hard drive, then to the rear of the optical drive.

Figure 2-55Connecting the Power and Data Cables

12.Connect the SATA data cable to the black eSATA connector on the system board labeled ESATA unless an eSATA adapter is installed. If an eSATA adapter is installed, connect the SATA data cable to the light blue SATA connector on the system board labeled SATA1.

NOTE: Refer to System Board Drive Connections on page 41 for an illustration of the system board drive connectors.

13.Route the data cable through the cable guides.

CAUTION: There are two cable guides that keep the data cable from being pinched by the drive cage when raising or lowering it. One is located on the bottom side of the drive cage. The other is located on the chassis frame under the drive cage. Ensure that the data cable is routed through these guides.

Installing and Removing Drives 47

Image 53

Contents Hardware Reference Guide Product Notice About This Book Iv About This Book Table of contents Preventing Electrostatic Damage Grounding Methods Standard Configuration Features Product FeaturesFront Panel Components Drive configuration may vary by model2Rear Panel Components Rear Panel ComponentsChanging from Desktop to Tower Configuration Installing the Optional Port Cover 7Cable Routing Serial Number LocationHardware Upgrades Replacing the Computer Access Panel Removing the Computer Access PanelRemoving the Front Bezel 5Installing the Optical Drive Bezel Hardware Upgrades Installing an Optical Drive BezelReplacing the Front Bezel Removing a Bezel BlankDDR3-SDRAM DIMMs Installing Additional MemoryDIMMs 1DIMM Socket Locations Populating Dimm SocketsInstalling DIMMs Page Page 2System Board Expansion Slot Locations Installing a Half-Height Expansion Card1324-volt and 12-volt Powered USB Connectors Installing a 12-Volt Powered USB Expansion CardPage Page Page Page Page Installing a Second DisplayPort Expansion Card Page Page 4Riser Card Configurations Installing a Full-Height Expansion Card25Powered Serial Ports Installing a Powered Serial Port Expansion CardPage Page Close the expansion card retention latch Replacing the Riser Card Configuring Powered Serial PortsPage 35Removing the Lower Expansion Slot Cover Hardware Upgrades 37Removing the Riser Card Bracket Replacing the Riser Card 39Installing the Riser Card Hardware Upgrades Page Close the expansion card retention latch Drive Positions Installing and Removing Drives45Extra Guide Screw Locations 8System Board Drive Connections System Board Drive ConnectionsRemoving an Optical Drive from the 5.25-inch Drive Bay Page 50Removing the 5.25-inch Drive Installing an Optical Drive into the 5.25-inch Drive BayPage Page Page Removing a Secondary Hard Drive from the 3.5-inch Drive Bay Page 60Installing a Secondary Hard Drive Hardware Upgrades Page 63Raising the Power Supply Hardware Upgrades Page Page 67Installing the Hard Drive Installing and Removing Drives Page Type Replacing the Battery69Removing and Replacing a Coin Cell Battery Type HP Keyed Cable Lock Installing a Security LockPadlock HP Business PC Security Lock Page Page Page Front Bezel Security Page Optional Integration Tray and Accessories Page Grounding Methods Preventing Electrostatic DamageComputer Operating Guidelines and Routine Care Cleaning Optical Drive PrecautionsSafety Shipping PreparationIndex USB