HP rp5000 Point of Sale manual Installing Additional Memory, DDR1-SDRAM DIMMs

Page 14

Hardware Upgrades

Installing Additional Memory

The computer comes with double data rate synchronous dynamic random access memory (DDR1-SDRAM) dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to two industry-standard DIMMs. These memory module slots are populated with at least one preinstalled memory module. To achieve the maximum memory support, you can populate the system board with up to 2 GB of memory.

DDR1-SDRAM DIMMs

For proper system operation, if the computer supports unregistered non-ECC DDR1-SDRAM DIMMs, the DIMMs must be:

industry-standard 184-pin

2.5 volt DDR1-SDRAM DIMMs

unbuffered PC2100 266 MHz-, PC2700 333 MHz-, or PC3200 400 MHz-compliant

Though a PC3200 400 MHz DIMM can be installed, a memory frequency of 400MHz is not supported; therefore, the PC3200 DIMM functions at 266MHz or 333MHz, depending on the frequency of the processor front side bus.

The DDR1-SDRAM DIMMs must also:

support CAS latency 2 or 2.5 (CL = 2 or CL = 2.5)

contain the mandatory JEDEC SPD information

In addition, the computer supports:

64 Mbit, 128 Mbit, 256 Mbit, and 512 Mbit non-ECC memory technology

single-sided or double-sided DIMMS (does not support double-sided X16 DDR1 DIMMS)

2-4

www.hp.com

Hardware Reference Guide

Image 14
Contents Hardware Reference Guide Hardware Reference Guide Contents Index Product Features Standard Configuration FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsWindows Logo Key Windows Logo Key FunctionsRemoving the Serial Port Cap Serial Number and Product Number Location Hardware Upgrades Serviceability FeaturesRemoving the Computer Access Panel and Front Bezel Removing the Front Bezel DDR1-SDRAM DIMMs Installing Additional MemoryDIMMs Installing DDR1-SDRAM DIMMs Locate the memory module sockets Installing a Dimm Removing the Expansion Card Cage Removing the Expansion Card Cage Installing an Expansion Card Install the expansion card Removing the HP USB+Power Card To replace the USB+Power card, reverse the above procedure Installing Additional Drives Locating Drive Positions Desktop Drive PositionsRemoving an Optical Drive or Diskette Drive Removing the Optical Drive or Diskette Drive Installing a 5.25-inch Bezel Blank Installing an Optional Optical Drive Installing Guide Screws in the Optical Drive Installing the Optical Drive Connecting the Power and Flat Ribbon Cable Upgrading the Hard Drive Removing and Replacing the Hard DriveRemoving the Hard Drive Installing a Drive into the 3.5-inch Drive Bay Guide Screw Locations Removing the Diskette Drive Bezel Installing a Hard Drive into the 3.5-inch Drive Bay Replacing the 3.5-inch Bezel Page Specifications HP Point of Sale System rp5000Power Supply 115 230 Powered Serial Port Configuration Serial Port Jumper Positions Serial Port Jumper Locations Page Guidelines for Installing Ultra ATA Devices Hard Drive Installation GuidelinesUsing the Cable-Select Feature with Ultra ATA Devices Conductor Ultra ATA Cable Battery Replacement Type Type Replacing a Coin Cell Battery Type Installing a Security Lock Security Lock ProvisionsInstalling a Padlock Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Electrostatic Discharge Routine Computer Care Shipping Preparation Routine Computer CareSafety Optical Drive PrecautionsCleaning OperationShipping Preparation Page Index Index Index-3
Related manuals
Manual 60 pages 59.53 Kb