HP rp5000 Base Model Point of Sale, rp5000 Point of Sale Installing an Optional Optical Drive

Page 29

Hardware Upgrades

Installing an Optional Optical Drive

ÄCAUTION: If an optical drive is installed, you cannot install a secondary hard drive. There are not enough power supply connectors to support this configuration. Doing so could result in damage to the computer.

To install an optional optical drive:

1.Turn off the computer properly through the operating system, then turn off any external devices.

2.Disconnect the power cord from the power outlet and disconnect any external devices.

3.Remove the computer access panel and front bezel (see “Removing the Computer Access Panel and Front Bezel” in this chapter).

4.Remove the optical drive if present (see “Removing an Optical Drive or Diskette Drive” in this chapter).

5.Install two M3 metric guide screws in the lower holes on each side of the drive.

ÄCAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can damage the internal components of the drive.

Hardware Reference Guide

www.hp.com

2-19

Image 29
Contents Hardware Reference Guide Hardware Reference Guide Contents Index Standard Configuration Features Product FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsWindows Logo Key Functions Windows Logo KeyRemoving the Serial Port Cap Serial Number and Product Number Location Serviceability Features Hardware UpgradesRemoving the Computer Access Panel and Front Bezel Removing the Front Bezel DDR1-SDRAM DIMMs Installing Additional MemoryDIMMs Installing DDR1-SDRAM DIMMs Locate the memory module sockets Installing a Dimm Removing the Expansion Card Cage Removing the Expansion Card Cage Installing an Expansion Card Install the expansion card Removing the HP USB+Power Card To replace the USB+Power card, reverse the above procedure Installing Additional Drives Desktop Drive Positions Locating Drive PositionsRemoving an Optical Drive or Diskette Drive Removing the Optical Drive or Diskette Drive Installing a 5.25-inch Bezel Blank Installing an Optional Optical Drive Installing Guide Screws in the Optical Drive Installing the Optical Drive Connecting the Power and Flat Ribbon Cable Removing and Replacing the Hard Drive Upgrading the Hard DriveRemoving the Hard Drive Installing a Drive into the 3.5-inch Drive Bay Guide Screw Locations Removing the Diskette Drive Bezel Installing a Hard Drive into the 3.5-inch Drive Bay Replacing the 3.5-inch Bezel Page HP Point of Sale System rp5000 SpecificationsPower Supply 115 230 Powered Serial Port Configuration Serial Port Jumper Positions Serial Port Jumper Locations Page Guidelines for Installing Ultra ATA Devices Hard Drive Installation GuidelinesUsing the Cable-Select Feature with Ultra ATA Devices Conductor Ultra ATA Cable Battery Replacement Type Type Replacing a Coin Cell Battery Type Security Lock Provisions Installing a Security LockInstalling a Padlock Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Electrostatic Discharge Routine Computer Care Routine Computer Care Shipping PreparationCleaning Optical Drive PrecautionsSafety OperationShipping Preparation Page Index Index Index-3
Related manuals
Manual 60 pages 59.53 Kb