HP rp5000 Base Model Point of Sale manual Routine Computer Care Shipping Preparation

Page 57

G

Routine Computer Care and

Shipping Preparation

Routine Computer Care

Follow these suggestions to take care of the computer and monitor:

Operate the computer on a sturdy, level surface. Leave a 3-inch (7.6-cm) clearance at the back of the system unit and above the monitor to permit the required airflow.

Never operate the computer with the cover or side panel removed.

Never restrict the airflow into the computer by blocking the front vents or air intake. Do not place the keyboard, with the keyboard feet down, directly against the front of the desktop unit as this also restricts airflow.

Keep the computer away from excessive moisture, direct sunlight, and extremes of heat and cold. For information about the recommended temperature and humidity ranges for the computer, refer to Appendix A, “Specifications” in this guide.

Keep liquids away from the computer and keyboard.

Never cover the ventilation slots on the monitor with any type of material.

Turn off the computer before you do either of the following:

Wipe the exterior of the computer with a soft, damp cloth as needed. Using cleaning products may discolor or damage the finish.

Occasionally clean the air vents on the front and back of the computer. Lint and other foreign matter can block the vents and limit the airflow.

Hardware Reference Guide

www.hp.com

G-1

Image 57
Contents Hardware Reference Guide Hardware Reference Guide Contents Index Standard Configuration Features Product FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsWindows Logo Key Functions Windows Logo KeyRemoving the Serial Port Cap Serial Number and Product Number Location Serviceability Features Hardware UpgradesRemoving the Computer Access Panel and Front Bezel Removing the Front Bezel Installing Additional Memory DIMMsDDR1-SDRAM DIMMs Installing DDR1-SDRAM DIMMs Locate the memory module sockets Installing a Dimm Removing the Expansion Card Cage Removing the Expansion Card Cage Installing an Expansion Card Install the expansion card Removing the HP USB+Power Card To replace the USB+Power card, reverse the above procedure Installing Additional Drives Desktop Drive Positions Locating Drive PositionsRemoving an Optical Drive or Diskette Drive Removing the Optical Drive or Diskette Drive Installing a 5.25-inch Bezel Blank Installing an Optional Optical Drive Installing Guide Screws in the Optical Drive Installing the Optical Drive Connecting the Power and Flat Ribbon Cable Removing and Replacing the Hard Drive Upgrading the Hard DriveRemoving the Hard Drive Installing a Drive into the 3.5-inch Drive Bay Guide Screw Locations Removing the Diskette Drive Bezel Installing a Hard Drive into the 3.5-inch Drive Bay Replacing the 3.5-inch Bezel Page HP Point of Sale System rp5000 SpecificationsPower Supply 115 230 Powered Serial Port Configuration Serial Port Jumper Positions Serial Port Jumper Locations Page Hard Drive Installation Guidelines Using the Cable-Select Feature with Ultra ATA DevicesGuidelines for Installing Ultra ATA Devices Conductor Ultra ATA Cable Battery Replacement Type Type Replacing a Coin Cell Battery Type Security Lock Provisions Installing a Security LockInstalling a Padlock Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Electrostatic Discharge Routine Computer Care Routine Computer Care Shipping PreparationCleaning Optical Drive PrecautionsSafety OperationShipping Preparation Page Index Index Index-3
Related manuals
Manual 60 pages 59.53 Kb