HP rp5000 Base Model Point of Sale, rp5000 Point of Sale manual Hard Drive Installation Guidelines

Page 47

C

Hard Drive Installation Guidelines

Using the Cable-Select Feature with Ultra ATA Devices

Optional drives are available from HP in kits. The configuration of the drive employs a cable-select feature that identifies the drive as device 0 (master drive) or device 1 (slave drive).

Device 1 is the drive connected to the cable’s middle connector. Device 0 is the drive connected to the cable’s end connector (applies only to 80-conductor ATA cables). See “Guidelines for Installing Ultra ATA Devices” in this appendix for an example of an Ultra ATA cable.

HP hard drives ship with jumpers preset to cable-select mode; therefore, no jumper setting changes on the existing or optional drives are required. If you purchase a third-party hard drive, refer to the documentation included with the kit to ensure proper installation and configuration of cables.

✎If installing a second device on the primary controller, you must use an 80-conductor Ultra ATA cable for optimal performance. This cable is standard on some models.

Guidelines for Installing Ultra ATA Devices

When installing additional Ultra ATA drives, follow these guidelines:

■If using multiple Ultra ATA devices, HP recommends that the devices be split between the primary and secondary Ultra ATA channels for optimum performance. Use an additional Ultra ATA cable to connect the additional device to the system board.

Hardware Reference Guide

www.hp.com

C-1

Image 47

Contents Hardware Reference Guide Hardware Reference Guide Contents Index Standard Configuration Features Product FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsWindows Logo Key Functions Windows Logo KeyRemoving the Serial Port Cap Serial Number and Product Number Location Serviceability Features Hardware UpgradesRemoving the Computer Access Panel and Front Bezel Removing the Front Bezel DDR1-SDRAM DIMMs Installing Additional MemoryDIMMs Installing DDR1-SDRAM DIMMs Locate the memory module sockets Installing a Dimm Removing the Expansion Card Cage Removing the Expansion Card Cage Installing an Expansion Card Install the expansion card Removing the HP USB+Power Card To replace the USB+Power card, reverse the above procedure Installing Additional Drives Desktop Drive Positions Locating Drive PositionsRemoving an Optical Drive or Diskette Drive Removing the Optical Drive or Diskette Drive Installing a 5.25-inch Bezel Blank Installing an Optional Optical Drive Installing Guide Screws in the Optical Drive Installing the Optical Drive Connecting the Power and Flat Ribbon Cable Removing and Replacing the Hard Drive Upgrading the Hard DriveRemoving the Hard Drive Installing a Drive into the 3.5-inch Drive Bay Guide Screw Locations Removing the Diskette Drive Bezel Installing a Hard Drive into the 3.5-inch Drive Bay Replacing the 3.5-inch Bezel Page HP Point of Sale System rp5000 SpecificationsPower Supply 115 230 Powered Serial Port Configuration Serial Port Jumper Positions Serial Port Jumper Locations Page Guidelines for Installing Ultra ATA Devices Hard Drive Installation GuidelinesUsing the Cable-Select Feature with Ultra ATA Devices Conductor Ultra ATA Cable Battery Replacement Type Type Replacing a Coin Cell Battery Type Security Lock Provisions Installing a Security LockInstalling a Padlock Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Electrostatic Discharge Routine Computer Care Routine Computer Care Shipping PreparationOperation Optical Drive PrecautionsCleaning SafetyShipping Preparation Page Index Index Index-3

Related manuals

Manual 60 pages 59.53 Kb