HP rp5000 Point of Sale, rp5000 Base Model Point of Sale manual Conductor Ultra ATA Cable

Page 48

Hard Drive Installation Guidelines

80-conductor Ultra ATA cable:

18 inches maximum total length, 80-conductor cable with maximum spacing of 6 inches between Device 0 and Device 1.

80-Conductor Ultra ATA Cable

1Device 0 (master drive) connector

2Device 1 (slave drive) connector

3System board connector

For optimal performance, connect hard drives to the primary controller. Connect expansion devices, such as ATA optical drives, tape drives, and diskette drives, to the secondary controller.

Install either a third-height or a half-height drive into a half-height bay.

Install guide screws to ensure that the drive lines up correctly in the drive cage. HP has provided extra guide screws installed in the front of the computer chassis behind the front bezel. Some options use M3 metric hardware. HP-supplied metric screws are black. HP-supplied standard screws are silver.

If only one device is connected to a cable, that device must be attached to the end (Device 0) connector.

If you have only one device, make sure to connect it to the Device 0 connector. If you connect it to the Device 1 connector, the system will not recognize the device and you may get a “no fixed disk found” error message.

C-2

www.hp.com

Hardware Reference Guide

Image 48
Contents Hardware Reference Guide Hardware Reference Guide Contents Index Product Features Standard Configuration FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsWindows Logo Key Windows Logo Key FunctionsRemoving the Serial Port Cap Serial Number and Product Number Location Hardware Upgrades Serviceability FeaturesRemoving the Computer Access Panel and Front Bezel Removing the Front Bezel Installing Additional Memory DIMMsDDR1-SDRAM DIMMs Installing DDR1-SDRAM DIMMs Locate the memory module sockets Installing a Dimm Removing the Expansion Card Cage Removing the Expansion Card Cage Installing an Expansion Card Install the expansion card Removing the HP USB+Power Card To replace the USB+Power card, reverse the above procedure Installing Additional Drives Locating Drive Positions Desktop Drive PositionsRemoving an Optical Drive or Diskette Drive Removing the Optical Drive or Diskette Drive Installing a 5.25-inch Bezel Blank Installing an Optional Optical Drive Installing Guide Screws in the Optical Drive Installing the Optical Drive Connecting the Power and Flat Ribbon Cable Upgrading the Hard Drive Removing and Replacing the Hard DriveRemoving the Hard Drive Installing a Drive into the 3.5-inch Drive Bay Guide Screw Locations Removing the Diskette Drive Bezel Installing a Hard Drive into the 3.5-inch Drive Bay Replacing the 3.5-inch Bezel Page Specifications HP Point of Sale System rp5000Power Supply 115 230 Powered Serial Port Configuration Serial Port Jumper Positions Serial Port Jumper Locations Page Hard Drive Installation Guidelines Using the Cable-Select Feature with Ultra ATA DevicesGuidelines for Installing Ultra ATA Devices Conductor Ultra ATA Cable Battery Replacement Type Type Replacing a Coin Cell Battery Type Installing a Security Lock Security Lock ProvisionsInstalling a Padlock Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Electrostatic Discharge Routine Computer Care Shipping Preparation Routine Computer CareOptical Drive Precautions CleaningSafety OperationShipping Preparation Page Index Index Index-3
Related manuals
Manual 60 pages 59.53 Kb