HP 620n Fast Ethernet Print Server manual Remove Power to Printer, Install the Hardware, RJ-45

Page 12

Remove Power to Printer, Install the Hardware

Figure 2-1 Remove Power, Install and Connect the Card

RJ-45

1.Turn off the printer and remove the printer’s power cord.

2.Identify an available HP Enhanced I/O (EIO) slot (typically, in the back of the printer).

Note	For printers with multiple EIO slots, you can install
	the print server into any EIO slot in the HP printer.

3.If the slot has a cover plate, remove it.

4.Insert the print server card. Align the card with the guide rails in the slot.

5.Press the card into the slot until firmly seated and tighten each retaining screw a little at a time until both screws are secure.

6.Connect the network cable to the card using the RJ-45 connector port.

7.Turn on the printer.

ENWW	Installation Procedures 12

Image 12

Contents HP Jetdirect Print Server Page Setup Guide HP Jetdirect Print Server Model 620n EIO Applicable Products Table of Contents HP Jetdirect Solutions Summary Introduction HP Jetdirect EIO Print ServerTypical HP Jetdirect Print Server Installation What You Need For Help Product Accessibility Installation Procedures Verify Printer Operation Remove Power to Printer, Install the Hardware RJ-45Verify Jetdirect Print Server Operation See in this guide for link configuration If Required, Configure Jetdirect With Your Network Settings Configuration ToolsMenus Adding a Printer to Your System Configuration Add the Printer to Your Network Server or SystemInstallation Procedures Client-Server Networks Unix Networks Troubleshooting Tools HP Jetdirect Configuration 10/100Base-TX Link ConfigurationLink-Speed LEDs On Autonegotiation is enabled, or OFF Autonegotiation is disabled, 10/100TXConfiguration has been manually set Port SelectResetting to Factory Defaults Controlling Network ProtocolsEnabling or Disabling Network Protocols Troubleshooting Tools Peer-to-Peer printing Client-Server printingNetwork Protocols Network AddressesSetting Up Your Network Printer Introduction to Network Printing HP Jetdirect Solutions Summary Tools Overview Embedded HP Jetdirect servicesSupported Network Protocols TCP/IPIPX/SPX DLC/LLCHP Installation Software HP Jetdirect Solutions Summary HP Jetdirect EIO Control Panel Menus Introduction Classic Control Panel CFG TCP/IP= CFG IPX/SPX= CFG LINK=WEB= HttpsTCP/IP Enable Graphical Control PanelHost Name Config MethodDhcp Release Dhcp RenewSettings Default IPManual Primary DNSIPX/SPX Enable Appltalk EnableDLC/LLC Enable Proxy ServerReset SecureWEB SecurityHP Jetdirect EIO Control Panel Menus Specifications and Regulatory Statements Electromagnetic For EU immunity compliance, seeRegulatory Statements FCC StatementsEuropean Community This equipment complies with Australian EMC requirementsWarranty Service HP Product Duration of Limited WarrantyYour Authorized Dealer HP Support and Service HP Support Online Firmware UpgradesHP Support By Phone Page 620SGEN