HP 620n Fast Ethernet Print Server manual Verify Jetdirect Print Server Operation

Page 13

Verify Jetdirect Print Server Operation

1.Print a Jetdirect Configuration page and check for status messages.

In most printers, a Jetdirect Configuration page will automatically print when you print a Printer Configuration page. See your printer documentation for instructions.

In HP Designjet printers, Jetdirect configuration information will be included on the Service Configuration print.

2.In the first section of the Jetdirect Configuration Page, look for the status message “I/O CARD READY”. See Figure 2-2.

This section of the configuration page also contains product- specific information, such as:

HP Jetdirect product number

Firmware revision number

LAN Hardware (MAC) address

Manufacturing identification number

3.If I/O CARD READY appears, the card has been installed successfully. Proceed to If Required, Configure Jetdirect With Your Network Settings.

If I/O CARD READY does not appear, check that you have:

Installed the print server correctly and properly connected the print server to the network

Verified that the network is operating properly

You can turn the printer off and then on again to reinitialize the print server and try again.

ENWW	Installation Procedures 13

Image 13

Contents HP Jetdirect Print Server Page Setup Guide HP Jetdirect Print Server Model 620n EIO Applicable Products Table of Contents HP Jetdirect Solutions Summary HP Jetdirect EIO Print Server IntroductionTypical HP Jetdirect Print Server Installation What You Need For Help Product Accessibility Installation Procedures Verify Printer Operation RJ-45 Remove Power to Printer, Install the HardwareVerify Jetdirect Print Server Operation See in this guide for link configuration Configuration Tools If Required, Configure Jetdirect With Your Network SettingsMenus Add the Printer to Your Network Server or System Adding a Printer to Your System ConfigurationInstallation Procedures Client-Server Networks Unix Networks 10/100Base-TX Link Configuration Troubleshooting Tools HP Jetdirect ConfigurationLink-Speed LEDs OFF Autonegotiation is disabled, 10/100TX On Autonegotiation is enabled, orConfiguration has been manually set Port SelectControlling Network Protocols Resetting to Factory DefaultsEnabling or Disabling Network Protocols Troubleshooting Tools Client-Server printing Peer-to-Peer printingNetwork Addresses Network ProtocolsSetting Up Your Network Printer Introduction to Network Printing Embedded HP Jetdirect services HP Jetdirect Solutions Summary Tools OverviewTCP/IP Supported Network ProtocolsIPX/SPX DLC/LLCHP Installation Software HP Jetdirect Solutions Summary HP Jetdirect EIO Control Panel Menus Introduction Classic Control Panel CFG TCP/IP= CFG LINK= CFG IPX/SPX=WEB= HttpsGraphical Control Panel TCP/IP EnableHost Name Method ConfigDhcp Release Dhcp RenewDefault IP SettingsManual Primary DNSAppltalk Enable IPX/SPX EnableDLC/LLC Enable Proxy ServerSecure ResetWEB SecurityHP Jetdirect EIO Control Panel Menus Specifications and Regulatory Statements For EU immunity compliance, see ElectromagneticFCC Statements Regulatory StatementsThis equipment complies with Australian EMC requirements European CommunityHP Product Duration of Limited Warranty Warranty ServiceYour Authorized Dealer Firmware Upgrades HP Support and Service HP Support OnlineHP Support By Phone Page 620SGEN