HP 620n Fast Ethernet Print Server manual Cfg Tcp/Ip=

Table C-1. EIO Classic Control Panel Menu (2 of 3)

Menu Item	Description
CFG TCP/IP=	Selects whether you want to access the TCP/IP menu
	and set TCP/IP protocol parameters.
	NO (default): Bypass the TCP/IP menu items.
	YES: Access the TCP/IP menu items.
	TCP/IP menus depend on your print server model.
	BOOTP=YES* enables configuration by a BootP
	server.
	DHCP=YES* enables configuration by a DHCP
	server. If DHCP=YES* and the print server has
	acquired a DHCP lease, you can choose to configure
	the following DHCP settings:
	RELEASE: Choose YES to release, or NO to save, the
	current DHCP lease.
	RENEW: Choose YES to renew the current DHCP lease,
	or NO not to renew the DHCP lease.
	AUTO IP=YES* will configure a link-local address.
	In these cases, manual configuration is turned off.
	If you specify BOOTP=NO, DHCP=NO, you can
	choose AUTO IP=YES to have a link-local address
	169.254.x.x assigned automatically.
	If BOOTP, DHCP and AUTO IP are disabled, you can
	manually set the following TCP/IP parameters from the
	control panel:
	Each byte of the IP address (IP)
	Subnet Mask (SM)
	Syslog Server (LG)
	Default Gateway (GW)
	Idle Timeout period (default is 270 seconds, 0 disables
	the timeout)
	CFG DNS 1=YES* will allow you to specify the IP
	address of a primary DNS server, one byte at a
	time.
	CFG DNS 2=YES* will allow you to specify the IP
	address of a secondary DNS server, one byte at a
	time.
	Print a Jetdirect configuration page to verify your
	settings. However, note that the print server may
	overwrite selected parameters with values that ensure
	proper operation.

ENWW HP Jetdirect EIO Control Panel Menus 37