HP MicroLogix 1761-NET-ENI manual Use any command supported by your controller

Peer-to-Peer Messaging 5-5

Open the message instruction and enter the appropriate variables. The variables are described in Table 5.4.

Table 5.4 Message Instruction Variables for Sending a Message to a Destination

Controller

Variable	Setting
This Controller Parameters:
Communication Command	Use any command supported by your controller.
Data Table Address	Use any valid file.
Size in Elements	For all ENI data configuration, always set this to 4 (4 words).
Channel	The RS-232 communication channel that is connected to the
	ENI, typically 0 or 1.
Target Device Parameters:
Message Timeout	Leave this value at the default.
Data Table Offset	Always 0.
Local Node Addr (dec).	The destination node address, Nodes 0 to 49.
Local/Remote	Always Local.

Publication 1761-UM006A-EN-P - February 2001