HP MicroLogix 1761-NET-ENI manual Use any command supported by your controller, Mail messages

6-6E-Mail Messages (Node 50 to 99)

2.Open the message instruction and enter the appropriate variables. The variables are described in Table 6.1.

Table 6.1 Message Instruction Variables for Sending an E-Mail Message

Variable	Setting
This Controller Parameters:
Communication Command	Use any command supported by your controller.
Data Table Address	Any valid string, such as ST25:21 as shown below.
Size in Elements	1
Channel	The RS-232 communication channel that is connected to the
	ENI, typically 0 or 1.
Target Device Parameters:
Message Timeout	Leave this value at the default.
Data Table Offset	Always 0.
Local Node Addr (dec).	This is the destination node address. Nodes 50 to 99 send
	e-mail messages.
Local/Remote	Always Local.

Publication 1761-UM006A-EN-P - February 2001