HP manual OLA/R Restrictions for the A4800A, A4800-60001 Default Scsi Attribute Values, Step

Installing the A4800A Adapter

Looking at Adapter Installation

OLA/R Restrictions for the A4800A

The HBA has some restrictions in the OLA/R procedure. These restrictions are explained below.

The restrictions are necessary because the SCSI attributes of initiator

ID, and speed cannot be changed online for this HBA.

OLA of A4800-60001The HBA can be online added only if the SCSI attribute values of initiator ID and speed are usable in your configuration. These values will be set to the current PDC (Processor Dependent Code) values (if any) or default to the new HBA’s values (see Table 2-2).

		Table 2-2	A4800-60001 - Default SCSI Attribute Values
			Attribute	Default Value
			Initiator ID	7
			Speed	Fast
		If these attributes are not acceptable, you must reboot the system to
		access the Boot Console Handler (BCH) prompt and then change the
		values in the PDC.
		OLR of A4800-60001the A4800-60001 can be Online Replaced without
		special considerations. See the Configuring HP-UX Peripherals manual
		for the steps that are necessary to OLR this HBA.
		Install/Replace With System Powered Down
		Check the manual supplied with the server to perform the following
		installation:
Step	1.	Shut down the operating system.
Step	2.	Power off the system and disconnect the power cord and cables.
Step	3.	Access the back of the server cabinet following the instructions in the
		server documentation. Refer to the server documentation for instructions
		on disassembling the server and installing host bus adapters.

22 Chapter 2