Installing the A4800A Adapter
Looking at Adapter Installation
| must invoke the appropriate commands in the SCSI section of the BCH |
| and change the address electronically to whatever is required for the HA |
| configuration being used. Refer to “Checking SCSI Bus Compatibility” on |
| page 36. |
| Do not change for MPE/iX. You may need to change "rate" setting. |
NOTE | |
|
|
Step 10. | Reassemble the server. |
Step 11. | Power on the system and reboot the operating system. |
Step 12. | The A4800A adapter runs an automatic self test. Error messages, if any |
| are generated, appear on the system console. |
24 | Chapter 2 |