Troubleshooting
Checking SCSI Bus Compatibility
Setting SCSI IDs
To use the SCSI command to set the initiator (SCSI) ID for an adapter, follow this syntax:
SCSI init bus_number slot_number ID_number
where
bus_number Specifies the number of the bus the adapter is installed on.
slot_number Specifies the number of the slot the adapter is in.
ID_num | Specifies the adapter’s SCSI ID number. |
For example, to set the SCSI ID for the adapter installed on bus 5 slot 2 to 6 and then display the results, issue these commands:
SCSI init 5 2 6
SCSI init 5 2
The output (of the second command) could look something like this:
PCI device /5.2 = 6
40 | Chapter 3 |