SECTION 6: VENTING
are located and other spaces of the building. Turn on clothes dryers and any exhaust fans, such as range hoods and bathroom exhausts so that they shall operate at maximum speed. Do not operate a summer exhaust fan. Close fireplace dampers.
4.Follow the lighting instructions. Place the appliance being inspected in operation. Adjust thermostat so that the appliance will operate continuously.
5.For any appliance having a draft hood, test for draft hood appliance spillage at the draft hood relief opening after 5 minutes of main burner operation. Use the flame of a match or candle.
6.After it has been determined that each appliance connected to the venting system properly vents when tested as outlined above, return doors, windows, exhaust fans, fireplace dampers and any other
7.If improper venting is observed during any of the above tests, the venting system must be corrected by a contractor qualified in the installation and service of
must be in accordance with the appropriate local codes and the NFPA 54/ANSI Z223.1 - latest revision, National Fuel Gas Code (US) or Standard CSA B149.1 Natural Gas and Propane Installation Code (Canada).
Figure 9: Vent and Roof Detail
Figure 10: Standard Vented Heater - Vertical and Horizontal Vent Termination
|
|
| Vent Terminal | NOTE: Vent supports not |
|
|
| shown. | |
|
|
|
| |
|
| Flashing |
|
|
|
| (By Others) |
|
|
|
| Listed |
|
|
|
| Thimble |
|
|
| (2" [5 cm] |
| Listed | |
| Clearance) |
| ||
|
| 4" (10 cm) |
| Thimble |
|
|
| (2" [5 cm] Clearance) | |
|
| Diameter Vent |
|
|
|
| Vertical | Horizontal | Flashing |
|
| Option | (By Others) | |
|
|
| Option |
|
|
|
|
| Vent |
|
|
|
| Terminal |
|
|
| Vent |
|
|
|
|
| 12" (31 cm) |
|
|
|
| Minimum |
Model | Vent Diameter | Part Number |
|
|
UHA[X] 30 - 125 | 4" (10 cm) | 90502102 |
|
|
|
|
|
| 17 |