Roberts Gorden UHA[X][S] 60 To Turn the Heater Off, Simple Troubleshooting, LED Diagnostic Codes

Page 40
11.4.2 To Turn the Heater Off

UHA LOW PROFILE UNIT HEATER INSTALLATION OPERATION AND SERVICE MANUAL

2.The automatic firing sequence will begin as described on Page 30, Figure 16. The heater will now operate automatically under the control of the on site controls.

11.4.2 To Turn the Heater Off

Set the thermostat to the "OFF" position. The burner will turn off immediately.

The fan will continue to run for 90 seconds. To restart, turn the thermostat above room temperature.

11.5 Simple Troubleshooting

Some possible reasons for the heater not operating are:

1.Gas supply not "ON".

2.Electricity supply not "ON".

3.The time and/or temperature controls are not "ON".

4.A limit switch may have operated. This may be caused by an interruption of the electrical supply, failure of the distribution fan or vent or

heat exchanger blockage.

If a temperature limit switch persistently trips, there is a fault which must be investigated by a contractor qualified in the installation and service of gas-fired heating equipment.

11.5.1 Simple Troubleshooting (Burner Faults)

If the burner fails to ignite for any reason, it will retry for ignition (four trials total). After four unsuccessful ignition trials, the control will put the heater into lockout for one hour.

Lockout should not occur during normal operation of the heater and indicates there is a fault condition which must be corrected. There is an LED light on the ignition control that flashes codes to assist in fault correction. See Page 34, Figure 20 for LED indication codes.

Figure 20: LED Diagnostic Codes

LED INDICATION

FAULT MODE

 

 

Slow Flash

Normal Operation - No call for heat.

 

 

Fast Flash

Normal Operation - Call for heat.

 

 

2 Flashes

Ignition Lockout - No flame detected.

 

 

3 Flashes

Airflow Fault - Pressure switch open or closed.

 

 

4 Flashes

Temperature Limit or

 

Manual Reset Limit Switch Open

 

 

5 Flashes

Flame Sense Error - Gas valve not energized.

 

 

Steady On

Internal Control Failure

 

 

34

Image 40
Contents Installation, Operation & Service Manual CombatUHA-Series Tubular Unit Heaters Low Profile Range Models UHAXS 30, 45, 60, 75, 100,Page 2008 Roberts-GordonLLC TABLE OF CONTENTSPrinted in U.S.A Page TABLE OF FIGURES Page 1.1 Manpower Requirements SECTION 1: HEATER SAFETY1.2 Safety Labels and Their Placement Figure 1: UHA 30 - 45 Label Placement For separated combustion units onlyFigure 2: UHA 60 - 75 Label Placement For separated combustion units onlyFigure 3: UHA 100 - 125 Label Placement For separated combustion units onlySECTION 2: INSTALLER RESPONSIBILITY 2.1 Wall Tag2.2 Corrosive Chemicals 2.3 National Standards and Applicable Codes3.4 Minimum Required Installation Clearances 3.2 Manufactured Units3.5 Clearances to Combustibles 3.6 Ventilation3.8 Electrical Supply 3.7 Gas Supply3.9 Vent 4.1 Gas Codes 4.2 Aircraft Hangars4.3 Parking Structures and Repair Garages 4.4 Electrical4.6 High Altitude SECTION 5: MAJOR COMPONENTS 5.1 General 5.2 Shelf Mounting and Suspension5.3 Wall Mounting Crush Hazard Use 3/8 threaded rod minimumFigure 6: Shelf-MountingMethods Figure 5: Suspension MethodsExisting cabinet screws must be re-used Description Part NumberWall Shelf Mounting Bracket Kit DescriptionFigure 8: Vertical Louvers Optional Push inlouver and compress spring to remove6.3 Vent Installation SECTION 6 VENTING6.1 Changing Vent and Air Intake Orientation 6.2 Venting6.4 Unvented Operation 6.3.1Standard Vented Heaters Models UHAX 30 -6.5 Horizontal Venting 6.6 Vertical Venting 6.7 Length Requirements6.7.1 Maximum Vent Lengths 6.8 Vent MaterialFigure 9: Vent and Roof Detail VerticalHorizontal OptionPage Figure 13: Concentric Vent Box Vertical OptionHorizontal OptionVent Terminal 7.1 Separated Combustion Installation 7.2 Unvented InstallationSECTION 7 AIR SUPPLY 7.3 Building Ventilation8.1 Connections SECTION 8: GAS PIPINGFigure 15: Gas Connection SECTION 9: WIRING 9.1 Positioning Thermostats9.1.1 Fan Control 9.2 Low Voltage Thermostat with One HeaterModel Relay TypeRelay Part Number UHAXS 30 -UHAXS 60 - DPST90436300 Max. Number of Heaters9.5 Internal Wiring Diagram 9.6 Ladder Wiring Diagram 9.7 Electrical Connection to the Heater SECTION 10: OPERATION AND MAINTENANCE 10.1 Pre-Start-UpChecks10.1.1 Louvers 10.1.2 Electrical ChecksFigure 16: Automatic Burner Control Sequence Figure 17: Gas Valve for Models UHAXS 30 -Required Incoming Signals Signals Output By Control10.2.3 Pressure Switch Figure 18: Gas Valve for Models UHAXS 60 -Check Gas Rate 10.2.4 Turning Off the Heater10.3 Complete Start-Up 10.2.5 External Controls10.3.1 Instruction to the User Reset Limit Switch - See Page 33, Section Figure 19: Manual Reset Limit SwitchSECTION 11: USER INSTRUCTIONS 11.1 User Instructions11.5 Simple Troubleshooting 11.5.1 Simple Troubleshooting Burner FaultsFigure 20: LED Diagnostic Codes 11.4.2 To Turn the Heater Off12.2 Burner Maintenance 12.3 Fan/Motor Assembly Maintenance12.4 Heat Exchanger Maintenance 12.5 Gas Valve Maintenance12.8 Maintenance Checklist 12.7 Venting and Air Intake PipeThe Vicinity of the Heater See Page 6, Sectionwhen installed Combustion Air IntakePipe Heat ExchangerSECTION 13: TROUBLESHOOTING 13.1 General STARTSECTION 13: TROUBLESHOOTING 13.3 Troubleshooting for Flame Supervision System 13.4Troubleshooting for Gas Valves 13.5Troubleshooting for Flue BlowerCorrect power STARTBurner Components SECTION 14 REPLACEMENT PARTS14.1 Gas Valve 14.2 Burner Compartment 14.2.1 Burner Injectors14.3 Ignition Electrode and Flame Probe 14.4 Heat Exchanger 14.5 Louver and Louver SpringsInstall Vertical screws Horizontal14.6 Flue Blower Vertical Installation 14.9 Axial Fan/Guard/Motor Assembly 14.7 Pressure Switch14.8 Ignition Control 14.9.1 Fan Removal and Replacement 14.9.2 To Replace the Fan Assembly14.10 Limit Switches 14.10.1 Removal and ReplacementSECTION 15: SPECIFICATIONS 15.1 Dimension Data TOP VIEWSIDE VIEW REAR VIEW15.2 General Technical Data Table All Models 15.3 Technical Data Table All ModelsWARRANTY IS VOID IF ROBERTS GORDON WILL PAY FORROBERTS GORDON WILL NOT PAY FOR Roberts-GordonPage OWNER WARRANTY REGISTRATION CARD About the InstallerPurchased From if different than installer Type of Installation check onePage Page Installation Clearances Fire Hazardclose to heater injury or property damage