| 2 How to Install Accessories In Your PC | |
| Installing Mass Storage Devices | |
| Installing a Flexible Disk Drive, | |
|
| |
WARNING | To take care to avoid electric shock and harm to your eyes by laser light | |
| from a | |
| drive should be serviced by authorized service personnel only. Refer to | |
| the label on the | |
| not attempt to make any adjustment of the laser unit. | |
| 1 | Switch off the display and computer, and disconnect the power |
| ||
|
| supply cables and any telecommunications cables. |
| 2 | Remove the computer’s cover (see page 13). |
| 3 | If present, remove the small cover plate on the shelf by removing the |
|
| two screws and pulling it out. |
| 4 | Check that the mounting rails are attached to the device with the |
|
| screws provided. |
| 5 | Slide the drive completely into the shelf. |
| 6 | Connect the power and data cables to the rear of the device (the |
|
| connectors are shaped to go in one way only). See “Internal |
|
| Connectors” on page 20 for more information about which |
|
| connectors to use. |
| 7 | Secure the device in position using the screws provided with the |
|
| device. |
| 8 | To allow access to the device, remove the relevant shelf cover plate |
|
| from the cover by pulling the plate from the left and unhinging its |
|
|
|
| 9 | Install any other accessories before replacing the cover. |
24