Accessing DPS Through Computer Setup
When the computer does not power on properly you should use Computer Setup to access the DPS program. To access DPS, perform the following steps:
1.Turn on or restart the computer.
2.When the F10 Setup message appears in the
NOTE: If you do not press the F10 key while the message is displayed, you must turn the computer off, then on again, to access the utility.
A choice of five headings appears in the Computer Setup Utilities menu:File, Storage, Security, Power, and Advanced.
3.Select Storage > DPS Self-Test.
The screen will display the list of
NOTE: If no
4.Select the hard drive to be tested and follow the screen prompts to complete the testing process. When the test has been completed, one of three messages will be displayed:
●Test Succeeded. Completion Code 0.
●Test Aborted. Completion Code 1 or 2.
●Test Failed. Drive Replacement Recommended. Completion Code 3 through 14.
If the test failed, the completion code should be recorded and reported to your service provider for help in diagnosing the computer problem.
ENWW | Accessing DPS Through Computer Setup 65 |