HP E1367A, E1366A manual Ieee 488.2 Common Commands, Command Title Description

IEEE 488.2 Common Commands

The following table lists the IEEE 488.2 Common (*) Commands that apply to the RF Multiplexer module. The operation of some of these commands is described in Chapter 4 of this manual. For information on Common Commands, refer to the HP B-size configuration guide or the ANSI/IEEE Standard 488.2-1987.

Command	Title	Description
*IDN?	Identification	Returns identification string of the switchbox.
*RST	Reset	Opens all channels, and invalidates current channel list for Opens all
		channels, and invalidates current channel list for scanning. Sets
		ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
*TST?	Self-Test	Always returns 0.
*OPC	Operation Complete	See note below.
*OPC?	Operation Complete Query	See note below.
*WAI	Wait to Complete	See note below.
*CLS	Clear status	Clears all status registers (see STATus:OPERation[:EVENt]?).
*ESE	Event status enable	See note below.
*ESE?	Event status enable query	See note below.
*ESR?	Event status register query	See note below.
*SRE	Service request enable	Enables status register bits (see Chapter 4 for operation).
*SRE?	Service request enable query	See note below.
*STB?	Read status byte query	See note below.
*TRG	Trigger	Triggers the switchbox to advance the scan when scan is enabled and
		trigger source is TRIGger:SOURce BUS.
*RCL	Recall instrument state	See note below.
*SAV	Store instrument state	See note below.

Note: These commands apply to many instruments and are not documented in detail here. See the

appropriate HP B-size or C-size configuration guide, or the ANSI/IEEE Standard 488.2-1987for more information.

Chapter 5 HP E1366A/E1367A RF Multiplexers Command Reference 59