HP 1350v, 1350xi, 1355, 1340 manual Reference guide

maintain your hp psc

After you have removed the plastic tape, install the print cartridge immediately to prevent the ink from drying in the nozzles.

5Hold the black print cartridge with the HP label on top. Slide the print cartridge at a slight angle into the right side of the print carriage. Press firmly until the print cartridge snaps into place.

Caution! Do not attempt to push the cartridge straight into the slot. It must slide in at a slight angle.

6Hold the tri-color print cartridge with the HP label on top. Slide the print cartridge at a slight angle into the left side of the print carriage.

Press firmly until the print cartridge snaps into place.

Caution! Do not attempt to push the cartridge straight into the slot. It must slide in at a slight angle.

Note: You must install both print cartridges in order for your HP PSC to work.

You can also refer to the label that is located on the inside of the print- carriage access door for information on installing the print cartridges.

7Close the print-carriage access door. Within a few minutes, a print cartridge alignment page prints. You will need to align the print cartridges.

For information on aligning the print cartridges, see align the print cartridges on page 37.

reference guide 35