ASRock IMB-A160-H manual Installation, Pre-installation Precautions

Page 13

Chapter 2: Installation

This is a Mini-ITX form factor motherboard. Before you install the mother- board, study the configuration of your chassis to ensure that the mother- board fits into it.

Pre-installation Precautions

Take note of the following precautions before you install motherboard com- ponents or change any motherboard settings.

1.Make sure to unplug the power cord before installing or removing the motherboard. Failure to do so may cause physical injuries to you and damages to motherboard com- ponents.

2.In order to avoid damage from static electricity to the moth- erboard’s components, NEVER place your motherboard directly on a carpet. Also remember to use a grounded wrist strap or touch a safety grounded object before you handle the components.

3.Hold components by the edges and do not touch the ICs.

4.Whenever you uninstall any components, place them on a grounded anti-static pad or in the bag that comes with the components.

5.When placing screws to secure the motherboard to the chassis, please do not over-tighten the screws! Doing so may damage the motherboard.

13

Image 13
Contents IMB-A160-H Disclaimer Copyright NoticeContents Uefi Setup Utility Introduction Package ContentsSpecifications Bios Feature ConnectorsRear Panel I/O Support CDPage ASRock Crashless Bios Unique FeaturesASRock Instant Flash IMB-A160 Motherboard LayoutLvds for IMB-A160 only LAN Port LED Indications I/O PanelPre-installation Precautions InstallationInstalling Memory Modules Dimm Expansion Slots PCI Express Slots Installing an Expansion CardInstalling Sata Hard Disks Power Connectors Pwrbtn Power Switch Installing the System PanelReset Reset Switch Pled System Power LEDPin LPT1 See p.10, No Onboard Headers and ConnectorsPIN CPU Fan Connector Inverter Power Control Header Optional Digital Input / Output Pin Header Jumpers Setup PWR-On Mode Jumper AT Mode Using Ahci Mode Operating System SetupSet Up Uefi Using Ahci Mode Set Up Uefi Use RAID Installation Guide to set the RAID configuration Running The Support CD Installing DriversDrivers Menu Utilities MenuHot Plug and Hot Swap for Hard Disk Drives What is Hot Plug and Hot Swap?Hot Plug / Hot Swap Operation Guide Points for attention, before you process Hot Plug / Hot Swap Step How to Hot Plug / Hot Swap a HDDHow to Hot Unplug / Hot Swap a HDD Uefi Menu Bar IntroductionNavigation Keys Main Screen Advanced Screen SVM Mode CPU ConfigurationCool ‘n’ Quiet North Bridge Configuration Restore on AC/Power Loss South Bridge ConfigurationOnboard HD Audio Front PanelSata Mode Storage ConfigurationSata IDE Combined Mode Sata ControllerSuper IO Configuration Acpi Configuration USB Mouse Power On USB Keyboard/Remote Power OnUSB 2.0 Controller USB ConfigurationLegacy USB Support TPM Support Trusted ComputingHardware Health Event Monitoring Screen CPU FAN1 SettingSetup Prompt Timeout Boot ScreenBootup Num-Lock Boot From Onboard LANSecurity Screen Exit Screen Load Uefi DefaultsSave Changes and Exit Discard Changes and Exit