ASRock IMB-A160-H manual Hardware Health Event Monitoring Screen, CPU FAN1 Setting

Page 47

3.4 Hardware Health Event Monitoring Screen

This section allows you to monitor the status of the hardware on your sys- tem, including the parameters of the CPU temperature, motherboard tem- perature, fan speed and voltage.

CPU FAN1 Setting

This allows you to set CPU FAN1’s speed. Configuration options: [Full On] and [Automatic Mode]. The default value is [Full On].

47

Image 47

Contents IMB-A160-H Disclaimer Copyright NoticeContents Uefi Setup Utility Introduction Package ContentsSpecifications Support CD ConnectorsBios Feature Rear Panel I/OPage ASRock Instant Flash Unique FeaturesASRock Crashless Bios IMB-A160 Motherboard LayoutLvds for IMB-A160 only LAN Port LED Indications I/O PanelPre-installation Precautions InstallationInstalling Memory Modules Dimm Expansion Slots PCI Express Slots Installing an Expansion CardInstalling Sata Hard Disks Power Connectors Pled System Power LED Installing the System PanelPwrbtn Power Switch Reset Reset SwitchPin LPT1 See p.10, No Onboard Headers and ConnectorsPIN CPU Fan Connector Inverter Power Control Header Optional Digital Input / Output Pin Header Jumpers Setup PWR-On Mode Jumper AT Mode Set Up Uefi Operating System SetupUsing Ahci Mode Using Ahci Mode Set Up Uefi Use RAID Installation Guide to set the RAID configuration Utilities Menu Installing DriversRunning The Support CD Drivers MenuHot Plug / Hot Swap Operation Guide What is Hot Plug and Hot Swap?Hot Plug and Hot Swap for Hard Disk Drives Points for attention, before you process Hot Plug / Hot Swap Step How to Hot Plug / Hot Swap a HDDHow to Hot Unplug / Hot Swap a HDD Uefi Menu Bar IntroductionNavigation Keys Main Screen Advanced Screen Cool ‘n’ Quiet CPU ConfigurationSVM Mode North Bridge Configuration Front Panel South Bridge ConfigurationRestore on AC/Power Loss Onboard HD AudioSata Controller Storage ConfigurationSata Mode Sata IDE Combined ModeSuper IO Configuration Acpi Configuration USB Mouse Power On USB Keyboard/Remote Power OnLegacy USB Support USB ConfigurationUSB 2.0 Controller TPM Support Trusted ComputingHardware Health Event Monitoring Screen CPU FAN1 SettingBoot From Onboard LAN Boot ScreenSetup Prompt Timeout Bootup Num-LockSecurity Screen Discard Changes and Exit Load Uefi DefaultsExit Screen Save Changes and Exit