ASRock IMB-A160-H manual How to Hot Plug / Hot Swap a HDD, Step

Page 32

How to Hot Plug / Hot Swap a HDD:

Please follow the instructions below to process Hot Plug / Hot Swap. Improper procedures will cause the HDD damage and data loss.

Step 1

Please connect the SATA power Step 2 cable’s 1x4-pin end (White) to

the power supply’s 1x4-pin cable.

Connect the SATA data cable to the motherboard’s SATA connector.

SATA power cable 1x4- pin power connector (White)

Step 3

Connect the SATA 15-pin power Step 4 cable connector’s (Black) end to

the HDD.

Connect the SATA data cable to the HDD.

32

Image 32

Contents IMB-A160-H Copyright Notice DisclaimerContents Uefi Setup Utility Package Contents IntroductionSpecifications Connectors Bios FeatureRear Panel I/O Support CDPage ASRock Instant Flash Unique FeaturesASRock Crashless Bios Motherboard Layout IMB-A160Lvds for IMB-A160 only I/O Panel LAN Port LED IndicationsInstallation Pre-installation PrecautionsInstalling Memory Modules Dimm Installing an Expansion Card Expansion Slots PCI Express SlotsInstalling Sata Hard Disks Power Connectors Installing the System Panel Pwrbtn Power SwitchReset Reset Switch Pled System Power LEDOnboard Headers and Connectors Pin LPT1 See p.10, NoPIN CPU Fan Connector Inverter Power Control Header Optional Digital Input / Output Pin Header Jumpers Setup PWR-On Mode Jumper AT Mode Set Up Uefi Operating System SetupUsing Ahci Mode Using Ahci Mode Set Up Uefi Use RAID Installation Guide to set the RAID configuration Installing Drivers Running The Support CDDrivers Menu Utilities MenuHot Plug / Hot Swap Operation Guide What is Hot Plug and Hot Swap?Hot Plug and Hot Swap for Hard Disk Drives Points for attention, before you process Hot Plug / Hot Swap How to Hot Plug / Hot Swap a HDD StepHow to Hot Unplug / Hot Swap a HDD Introduction Uefi Menu BarNavigation Keys Main Screen Advanced Screen Cool ‘n’ Quiet CPU ConfigurationSVM Mode North Bridge Configuration South Bridge Configuration Restore on AC/Power LossOnboard HD Audio Front PanelStorage Configuration Sata ModeSata IDE Combined Mode Sata ControllerSuper IO Configuration Acpi Configuration USB Keyboard/Remote Power On USB Mouse Power OnLegacy USB Support USB ConfigurationUSB 2.0 Controller Trusted Computing TPM SupportCPU FAN1 Setting Hardware Health Event Monitoring ScreenBoot Screen Setup Prompt TimeoutBootup Num-Lock Boot From Onboard LANSecurity Screen Load Uefi Defaults Exit ScreenSave Changes and Exit Discard Changes and Exit