ASRock IMB-A160-H manual Pin

Page 20

1.High Definition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instructions in our manual and chassis manual to install your system.

2.If you use an AC’97 audio panel, please install it to the front panel audio header by the steps below:

A.Connect Mic_IN (MIC) to MIC2_L.

B.Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to

OUT2_L.

C.Connect Ground (GND) to Ground (GND).

D.MIC_RET and OUT_RET are for HD audio panel only. You don’t need to connect them for AC’97 audio panel.

E.To activate the front mic.

For Windows® XP / XP 64-bit OS:

Select “Mixer”. Select “Recorder”. Then click “FrontMic”.

For Windows® 8 / 8 64-bit / 7 / 7 64-bit / VistaTM / VistaTM

64-bit OS:

Go to the “FrontMic” Tab in the Realtek Control panel. Adjust

“Recording Volume”.

Audio AMP Output Speaker Header

(4-pin SPEAKER_OUT1)

(see p.10, No. 34)

OUTLP

1

OUTRN

PIN

Signal Name

1

SPK L+

2

SPK L-

3

SPK R-

4

SPK R+

Chassis Fan Connector

(3-pin CHA_FAN1)

(see p.10, No. 38)

GND

+12V

FAN_SPEED

Please connect a fan cable to the fan connector and match the black wire to the ground pin.

20

Image 20
Contents IMB-A160-H Copyright Notice DisclaimerContents Uefi Setup Utility Package Contents IntroductionSpecifications Connectors Bios FeatureRear Panel I/O Support CDPage ASRock Instant Flash Unique FeaturesASRock Crashless Bios Motherboard Layout IMB-A160Lvds for IMB-A160 only I/O Panel LAN Port LED IndicationsInstallation Pre-installation PrecautionsInstalling Memory Modules Dimm Installing an Expansion Card Expansion Slots PCI Express SlotsInstalling Sata Hard Disks Power Connectors Installing the System Panel Pwrbtn Power SwitchReset Reset Switch Pled System Power LEDOnboard Headers and Connectors Pin LPT1 See p.10, NoPIN CPU Fan Connector Inverter Power Control Header Optional Digital Input / Output Pin Header Jumpers Setup PWR-On Mode Jumper AT Mode Set Up Uefi Operating System SetupUsing Ahci Mode Using Ahci Mode Set Up Uefi Use RAID Installation Guide to set the RAID configuration Installing Drivers Running The Support CDDrivers Menu Utilities MenuHot Plug / Hot Swap Operation Guide What is Hot Plug and Hot Swap?Hot Plug and Hot Swap for Hard Disk Drives Points for attention, before you process Hot Plug / Hot Swap How to Hot Plug / Hot Swap a HDD StepHow to Hot Unplug / Hot Swap a HDD Introduction Uefi Menu BarNavigation Keys Main Screen Advanced Screen Cool ‘n’ Quiet CPU ConfigurationSVM Mode North Bridge Configuration South Bridge Configuration Restore on AC/Power LossOnboard HD Audio Front PanelStorage Configuration Sata ModeSata IDE Combined Mode Sata ControllerSuper IO Configuration Acpi Configuration USB Keyboard/Remote Power On USB Mouse Power OnLegacy USB Support USB ConfigurationUSB 2.0 Controller Trusted Computing TPM SupportCPU FAN1 Setting Hardware Health Event Monitoring ScreenBoot Screen Setup Prompt TimeoutBootup Num-Lock Boot From Onboard LANSecurity Screen Load Uefi Defaults Exit ScreenSave Changes and Exit Discard Changes and Exit