ASRock IMB-A160-H Hot Plug and Hot Swap for Hard Disk Drives, Hot Plug / Hot Swap Operation Guide

Page 30

2.10 Hot Plug and Hot Swap for Hard Disk Drives

This motherboard supports Hot Plug and Hot Swap for SATA3 in AHCI / RAID mode. (Raid is not supported by AMD A50M)

What is Hot Plug and Hot Swap?

If the HDDs are NOT set for RAID, it is called “Hot Plug” for the action to insert and remove the HDDs while the system is still powered on and in working condition. If the HDDs are set for RAID then it is called “Hot Swap”. However, please note that it cannot perform Hot Plug or Hot Swap if the OS has been installed into the HDD.

Hot Plug / Hot Swap Operation Guide

Please read the operation guide of Hot Plug / Hot Swap below carefully. Before you process Hot Plug / Hot Swap, please check the cable accessories from the motherboard gift box pack below.

A. 7-pin SATA data cable

B. SATA power cable with SATA 15-pin power connector interface

A. SATA data cable (Red)

B. SATA power cable

 

 

 

 

 

 

 

 

 

 

 

 

SATA 7-pin connector

The SATA 15-pin power connector (Black) should be connected to your SATA3

HDD

The 1x4-pin conventional power connector (White) should be connected to a power supply

30

Image 30
Contents IMB-A160-H Copyright Notice DisclaimerContents Uefi Setup Utility Package Contents IntroductionSpecifications Rear Panel I/O ConnectorsBios Feature Support CDPage Unique Features ASRock Crashless BiosASRock Instant Flash Motherboard Layout IMB-A160Lvds for IMB-A160 only I/O Panel LAN Port LED IndicationsInstallation Pre-installation PrecautionsInstalling Memory Modules Dimm Installing an Expansion Card Expansion Slots PCI Express SlotsInstalling Sata Hard Disks Power Connectors Reset Reset Switch Installing the System PanelPwrbtn Power Switch Pled System Power LEDOnboard Headers and Connectors Pin LPT1 See p.10, NoPIN CPU Fan Connector Inverter Power Control Header Optional Digital Input / Output Pin Header Jumpers Setup PWR-On Mode Jumper AT Mode Operating System Setup Using Ahci ModeSet Up Uefi Using Ahci Mode Set Up Uefi Use RAID Installation Guide to set the RAID configuration Drivers Menu Installing DriversRunning The Support CD Utilities MenuWhat is Hot Plug and Hot Swap? Hot Plug and Hot Swap for Hard Disk DrivesHot Plug / Hot Swap Operation Guide Points for attention, before you process Hot Plug / Hot Swap How to Hot Plug / Hot Swap a HDD StepHow to Hot Unplug / Hot Swap a HDD Introduction Uefi Menu BarNavigation Keys Main Screen Advanced Screen CPU Configuration SVM ModeCool ‘n’ Quiet North Bridge Configuration Onboard HD Audio South Bridge ConfigurationRestore on AC/Power Loss Front PanelSata IDE Combined Mode Storage ConfigurationSata Mode Sata ControllerSuper IO Configuration Acpi Configuration USB Keyboard/Remote Power On USB Mouse Power OnUSB Configuration USB 2.0 ControllerLegacy USB Support Trusted Computing TPM SupportCPU FAN1 Setting Hardware Health Event Monitoring ScreenBootup Num-Lock Boot ScreenSetup Prompt Timeout Boot From Onboard LANSecurity Screen Save Changes and Exit Load Uefi DefaultsExit Screen Discard Changes and Exit