NuTone CV556, CV554, CV570 installation instructions Final System Check

Page 11

FLOOR INLET INSTALLATION

FLOOR

INLET

INLET

EXTENSION

29/16"

31/16"

FLOOR

 

SUB-FLOOR

 

 

FRAME

MOUNTING

 

BRACKET

 

 

SEAL

FIGURE 40

FLANGED

FITTING

FINAL SYSTEM CHECK

CUT TO

 

LENGTH

 

EXTENSION

 

SLEEVE

 

 

MOUNTING

 

BRACKET

FLANGED

FLANGE

 

FITTING

 

 

FIGURE 41

 

INLET

 

EXTENSION SLEEVE

FLANGED FITTING

BRACKET

TUBING

 

 

FIGURE 42

Be sure all inlets are closed and lower cannister is in place. Check switch on power unit for manual on/off operation.

Check each wall inlet to be sure contacts activate power unit when hose is inserted and switched on, if applicable. If Central Cleaning hose is not available at the time, a short piece of wire can be used to short contacts in wall inlet to activate power unit. Check each wall inlet and tubing connection for air leaks. Check power unit for leaks around inlet tube and dirt cannister.

Make sure the permanent cloth filter is properly installed in the power unit according to directions in the homeowner’s operating instructions.

Now it’s time to enjoy the benefits of a NuTone Central Cleaning System.

11

Image 11
Contents Installation in Existing Construction Installation InstructionsInstallation in NEW Construction SPLIT-LEVEL House System Planning and LayoutRanch Style House TWO-STORY HouseStacked Closets or Laundry Locating the Power UnitLocating Access Keys Existing Construction Tubing and Wall Inlet LocationsModel 329 for USE with 330 Inlets Installation in NEW ConstructionWall Inlet ROUGH-IN Model 361 for USE with 360 InletsInstalling the Tubing Installation in NEW ConstructionModel 330 Wall Inlet 329 Rough-in Wall Inlet InstallationModel 360 Wall Inlet 361 Rough-In Tube to prevent this condition. Refer to FigureInstallation in NEW Construction Minimum Wall Clearance Dimensions Power Unit InstallationTubing Connections AT Power Unit Dimensional ChartThan 1⁄2, a spacer must be used. See on page 6 as Guide Installation in Existing ConstructionModel 360 Series Inlets 361 Rough-In Model 330N Wall Inlet Installation 329 Rough-in Installation in Existing ConstructionFinal System Check Installation DES Prises AU SOL Instructions ’INSTALLATIONInstallation DU Groupe D’ASPIRATION Installation Dans UNE Construction ExistanteLA Maison a Plusieurs Niveaux Planification ET Disposition DU SystemeLA Maison a UN Etage Emplacement DU Groupe D’ASPIRATION Tuyauterie ET Emplacement DES Prises MuralesModele 329 Convient AUX Prises Installation Dans UNE Nouvelle ConstructionEncastrement DE Prise Murale Modele 361 Convient AUX PriseInstallation DE LA Tuyauterie Installation Dans UNE Nouvelle Construction suiteModele 360 Prise Murale Encastrement Installation DES Prises MuralesVue de derrier Dégagement Minimum AU MUR Installation DU Groupe DaspirationTableau DES Dimensions Modele CI370 OU Serie 360 DE Prises Encastrement Installation DES Prises MuraleInstallation DE Prise Murale Modele 330N Encastrement Installation Dans UNE Construction Existante suiteVerification Finale DU Systeme Installation DES Prises AU SOLTwo Year Limited Warranty