Raypak 2600401 operating instructions Econopak Water Heaters

Page 1

INSTALLATION & OPERATING

INSTRUCTIONS

Econopak

Water

Heaters

Models 0260–0401

Type WH

WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

This manual should be maintained in legible condition and kept adjacent to the heater or in a safe place for future reference.

Catalog No. 3000.51F

Effective: 04-08-09

Replaces: 03-25-08

P/N 240726 Rev. 7

Image 1
Contents Econopak Water Heaters Page Contents Are important but not related to personal injury hazards Time/Temperature Relationships in Scalds General SafetyTemperature Time to Produce Serious Burn Receiving Equipment General SpecificationsTank Code Requirements InstallationMounting Base ClearancesOutdoor Models Venting ConnectionsModels Model No Sq. in. of Each Free AreaModels 0260 Indoor ModelsVent Terminal/Indoor Stack Installation Vent Max Model No Connector Horizontal Diameter Length ftVent Pipe Draft Hood Heater Common VentsModel No Nat Pro Gas Supply ConnectionsSetting Gas Pressure Specifications Type Inches WC Regulator MinWater Connections & System Piping Gas Pressure Regulator0261 Low NOx WH1 with Pressure Relief Valve Relief ValveElectrical Wiring Standing Pilot Model Wiring DiagramsIntermittent Ignition Device IID Model Intermittent Ignition Device IID Models 0330 Intermittent Ignition Device IID Model 0261 Low NOx Intermittent Ignition Device IID Models 0331 & 0401 Low NOx Start-up Procedures Servicing ProceduresSequence of Operation Honeywellpilot Robertshaw Pilot For Automatic Ignition Models System Shut Down ProcedureFor Robertshaw Gas Valve Turn gas control To Turn Off Gas To Appliance Testing the Ignition Safety Shut-offControls Inspection ProceduresLow NOx Heaters-Models BurnersHigh/Low Gas Pressure Switch Burner AdjustmentOperation Visual InspectionRepair Section Heat Exchanger Removal Heat Exchanger Re-assemblyCombustion Chamber Removal Causes TroubleshootingPiping Intermittent Pilot System- Honeywell S8600 Electrical Electronic Ignition IIDElectrical Standing Pilot Adjustments & Replacement of Components Control Well Replacement Circulator ReplacementTube Replacement Procedure Procedure for Cleaning Flue Gas Passage WaysLimitedpartswarrantyeconopakwaterheaters Page Page