For Standing Pilot Model with Robertshaw Gas Valve, On/Off Operation
1.STOP! Read the safety information above.
2.Set the tankstat on the lowest setting.
3.Turn OFF all electric power to the heater.
4.Remove heater door panel.
5.Push in gas control knob slightly and turn clock- wise 
to "OFF".
GASCONTROL
KNOBSHOWN
IN"OFF"POSITION
GASINLET
Fig. 20: Robertshaw Gas Valve
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is pushed in slightly. Do not force.
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If your smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to the next step.
7.Locate pilot mounted on the right side of the burn- er drawer, right of first burner.
8.Turn knob on gas control 
to "Pilot".
9.Push in control knob all the way and hold in, immediately light the pilot with a match. Continue to hold control knob in for about one minute after the pilot is lighted, release knob and it will pop back up. Pilot should remain lighted. If it goes out, repeat steps 4 through 8.
* If knob does not pop up when released, stop and immediately call your service technician or gas supplier.
*If the pilot does not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.
10.Stand to the side of the heater and turn the gas control knob 
to "ON".
11.Replace heater door.
12.Turn "ON" all electrical power to the heater.
13.Set the tankstat to the desired setting.
For Standing Pilot Model with Honeywell Gas Valve, On/Off Operation
1.STOP! Read the safety information.
2.Set the tankstat to the lowest setting.
3.Turn Off all electrical power to the heater.
4.Remove heater door panel.
5.Turn gas control knob clockwise 
to "OFF".
GASCONTROL
KNOBSHOWN
IN"OFF"
POSITION
GASINLET
Fig. 22: Honeywell Gas Valve
HONEYWELLPILOT | ROBERTSHAW PILOT |
|
|
Fig. 21: Honeywell and Robertshaw Pilots
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to the next step.
7.Locate pilot mounted on the right side of the burn- er drawer, right of first burner.
8.Turn knob on gas control 
to "PILOT".
9.Push down and hold the red reset button in, imme- diately light the pilot with a match. Continue to hold down red reset button for about one minute after the pilot is lighted. Release red reset button and it will pop back up. Pilot should remain lighted. If it goes out, repeat steps 4 through 8.
23