Raypak 2600401 operating instructions Indoor Models, Models 0260

2.Attach mounting angles to heater jacket with 1/2" sheet metal screws, (4 places).

Fig. 4: Location of Mounting Angles

3.Lower outdoor top to heater and secure with 1" sheet metal screws.

	TEMPERATURE
	SENSOR
	MOUNTING
	SCREWS (2)
CONNECT ONE
VENT SENSOR	HARNESS
WIRE TO THE
	ASSEMBLY
HIGH LIMIT WIRE
CONNECT ONE
VENT SENSOR
WIRE TO THE
ROLL-OUT
SENSOR WIRE
WIRE FROM
TRANSFORMER
ROLL-OUT
SENSOR

Fig. 6: Mounting Flue Sensor

4.Remove door and locate wire from roll out sensor to Hi Limit with the male/female connector.

WIRE FROM TRANSFORMER

MALE/FEMALE

WIRE TERMINAL

WIRE FROM HIGH LIMIT

ROLL OUT SENSOR

Fig. 5: Long Side of Mounting Angle Located as Shown

Indoor Models

The drafthood is shipped separately and must be installed on the heater.

Models 0260 & 0261

1.Mount drafthood on top of heater and attach with the 4 sheet metal screws provided. Drafthood should be positioned with the vent sensor located on the front left side as shown.

2.Remove plastic plug from left side of heater jacket and install plastic grommet provided.

3.Route flue sensor wire harness through the grom- met installed in Step 2.

Fig. 7: Before Installation of Drafthood

WIRE FROM TRANSFORMER

CONNECT ONE VENT SENSOR WIRE

TO HIGH LIMIT WIRE

CONNECT ONE VENT SENSOR WIRE

TO ROLL OUT SENSOR WIRE

ROLL OUT SENSOR

Fig. 8: After Installation of Drafthood

5.Disconnect male/female connector and attach to the 2 wires from drafthood vent sensor harness.

10