Slant/Fin VSPH-180, VSPH-60 operating instructions Victory Vsph, Table of Contents

Page 1

™

VICTORY VSPH

®

This manual must be left with owner and should be hung on or adjacent to the boiler for reference.

DIRECT-VENT SEALED COMBUSTION BOILERS

HOT WATER MODELS VSPH-60 THROUGH VSPH-180

GAS-FIRED CAST-IRON BOILERS FOR NATURAL AND L.P. PROPANE GASES

INSTALLATION AND OPERATING INSTRUCTIONS

TABLE OF CONTENTS

 

Dimensions, Rating and Orifice Sizes

2

Identification of Parts

3

Installation Requirements

4

Venting Application

5

Boiler Room Air Supply and Ventilation

5

Flue gas Venting Requirements

5

Vent Material

5

Air Intake Material

6

Flue and Air Intake Restrictions

6

Non-Direct Vent Installation

8

Sidewall Venting, Non-Direct Vent

8

Vent Termination Location and Clearance

8

Non-Direct Vent Vertical Venting

8

Direct Vent Installation

8

Sidewall Venting, Direct Vent

8

Vent/Air Intake Termination Installation

8

Direct Vent, Venting and Air Intake through a Roof

13

Venting and Air Intake Regular Inspection

15

Gas Piping

15

Electrical Wiring

15

Multi Zoning

18

Water Piping

18

Wiring Diagram

16

Operating Instructions

19

Gas Input Rate Adjustment

20

Boiler Control

22

Sequence of Operation

21

Status of Indicator Lights (LED’s)

22

Safety Check

23

Care and Maintenance

24

General Troubleshooting Guide

25-27

WARNING

The venting system of this boiler is under positive pres- sure. Leakage from this system can be hazardous and if not avoided can result in death or serious injury. In addi- tion to the recommendations within this manual and the User’s Information Manual, the venting system, from the blower to the outdoor discharge, must be carefully checked annually by a qualified service agency.

IMPORTANT

READ ALL OF THE FOLLOWING WARNINGS AND STATEMENTS BEFORE READING THE INSTALLATION INSTRUCTIONS

WARNING

LIQUEFIED PETROLEUM (L.P.)

PROPANE GAS-FIRED BOILERS

Installation location ONLY as permitted in paragraph entitled "LIQUEFIED PETROLEUM (L.P.) PROPANE GAS-FIRED BOILER LOCATION" on page 4 of this instruction book.

The above warning does not apply to NATURAL gas- fired boilers.

The installation must conform to the requirements of the authority having jurisdiction or, in the absence of such requirements, to the National Fuel Gas Code, ANSI Z223.1-latest edition. The installation must also conform to the additional requirements in this Slant/Fin Instruction Book.

In addition where required by the authority having juris- diction, the installation must conform to American Society of Mechanical Engineers Safety Code for Controls and Safety Devices for Automatically Fired Boilers, No. CSD-1.

WARNING

This boiler, gas piping and accessories must be installed, connected, serviced and repaired by a trained, experienced service technician, familiar with all precautions required for gas-fired equipment and licensed or otherwise qualified, in compliance with the authority having jurisdiction.

Heating Contractor

Boiler Model Number

Address

Boiler Serial Number

Phone Number

Installation Date

Printed in U.S.A. 207

Part No. 455035 Publication No. VSPH-40 Rev. A

Page 1 Page 2
Image 1
Page 1 Page 2
Contents Victory Vsph Table of ContentsVictory Vsph Models Ratings and DimensionsBoiler Input No. Model Btuh Sections Location and Identification of Parts Base AssemblyNatural GAS-FIRED Boiler Location SafetyLiquefied Petroleum L.P. Propane GAS-FIRED Boiler Location Boiler FoundationDirect Vent Installation NON-DIRECT Vent InstallationVenting Application Boiler Room AIR Supply and VentilationFlue and AIR Intake Restrictions AIR Intake Pipe Material000 Ft 000 7,500 Ft 500 10,000 Ft VENT/AIR Intake Termination Installation Venting InstallationSidewall Venting NON-DIRECT Vent Vent Termination Location and ClearancesNon-direct vent, side wall venting Victory Vsph Models NON Direct VENT, Sidewall VentingAL 29-4C is a Registered Trademark of Allegheny Ludlum Corp Victory Vsph Models Victory Vsph Models Direct VENT, Sidewall Venting Vent/Air Intake Termination Direct Vent Venting and AIR Intake Through a RoofDirect VENT, Venting and AIR Intake Through a Roof Victory Vsph ModelsPower Supply Electrical WiringVenting and AIR Intake System Regular Inspection GAS PipingSchematic wiring diagram Multizoning of Vsph Boiler Multi Zoning Thermostat ConnectionsWater Piping Operating Instructions Safety Information Vsph Boiler Sequence of Operation Description of Operation Power TSTAT/CIRC LED Normal Operation Status of Indicator Lights LED’SLimit Press Switch Flame LED Integrated Boiler ControlLED’s Flashing Diagnostic Flash CodesIndication Remedy General Maintenance Care and MaintenanceCleaning II. Inspection During Heating SeasonBurners Fail to OPERATE- no Heat Cause General Troubleshooting Guide For Service PersonnelBurner will not Shut OFF Cause Not Enough Heat CauseBurner Short Cycles Cause Remedy If Replacement Parts are NeededFumes and GAS Odors Cause Remedy SLANT/FIN CORPORATION, Greenvale, N.Y Phone 516

VSPH-180, VSPH-60 specifications

Slant/Fin is a renowned name in the heating industry, renowned for its innovation, quality, and efficiency. Among its popular offerings are the VSPH-180 and VSPH-60, two highly efficient gas-fired residential boilers designed to provide reliable heating for homes.

The VSPH-180 is a high-efficiency residential boiler that delivers exceptional heating performance while being mindful of energy consumption. It operates at an impressive AFUE (Annual Fuel Utilization Efficiency) rating of up to 95%, meaning it uses 95% of the fuel burned for heating, resulting in lower energy bills and reduced environmental impact. The VSPH-180 features a durable stainless steel heat exchanger that not only contributes to its efficiency but also prolongs the boiler's lifespan.

On the other hand, the VSPH-60 is a slightly smaller but equally efficient model that is perfect for apartments or smaller homes. It also boasts a remarkable AFUE rating of up to 95%, ensuring cost-effective heating solutions. The compact design of the VSPH-60 allows for easy installation in various locations, making it a versatile choice for homeowners seeking space-saving options without compromising on performance.

One of the standout technologies in both models is the modulating gas valve, which adjusts the burner’s output to match the heating demand. This feature enhances energy efficiency by preventing the boiler from working harder than necessary, ensuring consistent temperatures and reducing wear on the unit. Furthermore, both models are equipped with a built-in electronic ignition system, eliminating the need for a pilot light and adding convenience for homeowners.

The VSPH series is designed with maintenance ease in mind. It features a user-friendly control panel that provides easy access to critical information, allowing for straightforward diagnostics and service. Regular maintenance can be performed with minimal disruption, enabling owners to keep their systems running optimally throughout the heating season.

In conclusion, the Slant/Fin VSPH-180 and VSPH-60 represent excellence in residential heating technology. With high AFUE ratings, durable construction, and advanced features, both boilers provide efficient and reliable heating solutions, ensuring comfort and energy savings for homeowners.
Top Page Image Contents