Slant/Fin VSPH-180, VSPH-60 General Troubleshooting Guide For Service Personnel

Page 25

VICTORY VSPH Models

25

 

 

 

BRUSH

TOP JACKET

FLUE COLLECTOR

INDUCER

Figure 22. Flue passage cleaning illustration

General Troubleshooting Guide For Service Personnel

WARNING: Only a trained, experienced service technician should perform troubleshooting. Turn off all electric power to the boiler before servicing.

A. BURNERS FAIL TO OPERATE- NO HEAT

CAUSE

1.No power, POWER LED off. Main electric switch open. Blown or defective line fuse.

2.Gas supply valve shut off. Gas valve knob is on “off” posi- tion. FLAME LED flashing.

3.Flame sensor contaminated.

4.Pilot flame too low.

5.Roll-out switch open. POWER and TSTAT/CIRC LED’s are on.

6.Harnesses plug-in connectors are not securely connected

7.Defective transformer.

REMEDY

1.Close switch. Check and replace

2.Open gas supply valve. Turn gas valve knob to “on “ posi- tion. Check gas pressure.

3.Clean sensor.

4.Adjust pilot flame.

5.Check roll-out switch for continuity replace if blown out (inspect flue passages prior to replacement).

6.Check connectors on boiler control.

7.Remove P2 connector from boiler control. Check trans- former terminals for 24V. Replace defective transformer.

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Victory Vsph Table of ContentsVictory Vsph Models Ratings and DimensionsBoiler Input No. Model Btuh Sections Location and Identification of Parts Base AssemblyNatural GAS-FIRED Boiler Location SafetyLiquefied Petroleum L.P. Propane GAS-FIRED Boiler Location Boiler FoundationDirect Vent Installation NON-DIRECT Vent InstallationVenting Application Boiler Room AIR Supply and VentilationFlue and AIR Intake Restrictions AIR Intake Pipe Material000 Ft 000 7,500 Ft 500 10,000 Ft VENT/AIR Intake Termination Installation Venting InstallationSidewall Venting NON-DIRECT Vent Vent Termination Location and ClearancesNon-direct vent, side wall venting Victory Vsph Models NON Direct VENT, Sidewall VentingAL 29-4C is a Registered Trademark of Allegheny Ludlum Corp Victory Vsph Models Victory Vsph Models Direct VENT, Sidewall Venting Vent/Air Intake Termination Direct Vent Venting and AIR Intake Through a RoofDirect VENT, Venting and AIR Intake Through a Roof Victory Vsph ModelsPower Supply Electrical WiringVenting and AIR Intake System Regular Inspection GAS PipingSchematic wiring diagram Multizoning of Vsph Boiler Multi Zoning Thermostat ConnectionsWater Piping Operating Instructions Safety Information Vsph Boiler Sequence of Operation Description of Operation Power TSTAT/CIRC LED Normal Operation Status of Indicator Lights LED’SLimit Press Switch Flame LED Integrated Boiler ControlLED’s Flashing Diagnostic Flash CodesIndication Remedy General Maintenance Care and MaintenanceCleaning II. Inspection During Heating SeasonBurners Fail to OPERATE- no Heat Cause General Troubleshooting Guide For Service PersonnelBurner will not Shut OFF Cause Not Enough Heat CauseBurner Short Cycles Cause Remedy If Replacement Parts are NeededFumes and GAS Odors Cause Remedy SLANT/FIN CORPORATION, Greenvale, N.Y Phone 516

VSPH-180, VSPH-60 specifications

Slant/Fin is a renowned name in the heating industry, renowned for its innovation, quality, and efficiency. Among its popular offerings are the VSPH-180 and VSPH-60, two highly efficient gas-fired residential boilers designed to provide reliable heating for homes.

The VSPH-180 is a high-efficiency residential boiler that delivers exceptional heating performance while being mindful of energy consumption. It operates at an impressive AFUE (Annual Fuel Utilization Efficiency) rating of up to 95%, meaning it uses 95% of the fuel burned for heating, resulting in lower energy bills and reduced environmental impact. The VSPH-180 features a durable stainless steel heat exchanger that not only contributes to its efficiency but also prolongs the boiler's lifespan.

On the other hand, the VSPH-60 is a slightly smaller but equally efficient model that is perfect for apartments or smaller homes. It also boasts a remarkable AFUE rating of up to 95%, ensuring cost-effective heating solutions. The compact design of the VSPH-60 allows for easy installation in various locations, making it a versatile choice for homeowners seeking space-saving options without compromising on performance.

One of the standout technologies in both models is the modulating gas valve, which adjusts the burner’s output to match the heating demand. This feature enhances energy efficiency by preventing the boiler from working harder than necessary, ensuring consistent temperatures and reducing wear on the unit. Furthermore, both models are equipped with a built-in electronic ignition system, eliminating the need for a pilot light and adding convenience for homeowners.

The VSPH series is designed with maintenance ease in mind. It features a user-friendly control panel that provides easy access to critical information, allowing for straightforward diagnostics and service. Regular maintenance can be performed with minimal disruption, enabling owners to keep their systems running optimally throughout the heating season.

In conclusion, the Slant/Fin VSPH-180 and VSPH-60 represent excellence in residential heating technology. With high AFUE ratings, durable construction, and advanced features, both boilers provide efficient and reliable heating solutions, ensuring comfort and energy savings for homeowners.
Top Page Image Contents