Slant/Fin VSPH-180, VSPH-60 Burner Short Cycles Cause Remedy, Fumes and GAS Odors Cause Remedy

Page 27

VICTORY VSPH Models

 

27

D. BURNER SHORT CYCLES

 

 

 

CAUSE

REMEDY

1.

Thermostat heat anticipator set too low.

1.

Reset anticipator.

2.

Excessive pressure drop due to excess venting or air intake

2.

System must be corrected.

 

system.

 

 

 

3.

Blockage or restriction in venting or air intake system.

3.

Check and Repair

4.

Defective air flow switch (out of adjustment).

4.

Replace. DO NOT adjust.

E. FUMES AND GAS ODORS

 

 

CAUSE

REMEDY

1.

Leaks in gas piping or accessories.

1.

Locate leaks and repair.

2.

Gas leaks in service line or meter connections.

2.

Close service supply valve - shut down boiler and notify

 

 

 

utility

3.

Condensation trap is not full of water.

3.

Check and fill with water.

4.

Venting system is physically damaged.

4.

Check carefully and repair. Also, see “Venting System

 

 

 

Regular Inspection”.

5.

Over - firing

5.

Adjust gas input to that shown on boiler rating plate.

IF REPLACEMENT PARTS ARE NEEDED

When parts are needed, refer to boiler model and serial number shown on the boiler name/rating plate. Refer to publication num- ber VSPH-10PL replacement parts for part numbers. Whenever possible refer to the original order by number and date.

Control identification and replacement should not be attempted by unskilled personnel. Only, simple easily - identified controls and parts may be obtained locally. All other controls and parts should be identified by and ordered from Slant/Fin. Relief/Safety valves must be ASME rated for the pressure and gross output of the boiler.

For replacement parts, heating contractors should contact their

Slant/Fin boiler distributor.

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Victory Vsph Table of ContentsRatings and Dimensions Victory Vsph ModelsBoiler Input No. Model Btuh Sections Location and Identification of Parts Base AssemblyBoiler Foundation SafetyNatural GAS-FIRED Boiler Location Liquefied Petroleum L.P. Propane GAS-FIRED Boiler LocationBoiler Room AIR Supply and Ventilation NON-DIRECT Vent InstallationDirect Vent Installation Venting ApplicationFlue and AIR Intake Restrictions AIR Intake Pipe Material000 Ft 000 7,500 Ft 500 10,000 Ft Vent Termination Location and Clearances Venting InstallationVENT/AIR Intake Termination Installation Sidewall Venting NON-DIRECT VentNon-direct vent, side wall venting Victory Vsph Models NON Direct VENT, Sidewall VentingAL 29-4C is a Registered Trademark of Allegheny Ludlum Corp Victory Vsph Models Victory Vsph Models Direct VENT, Sidewall Venting Vent/Air Intake Termination Direct Vent Venting and AIR Intake Through a RoofDirect VENT, Venting and AIR Intake Through a Roof Victory Vsph ModelsGAS Piping Electrical WiringPower Supply Venting and AIR Intake System Regular InspectionSchematic wiring diagram Multizoning of Vsph Boiler Thermostat Connections Multi ZoningWater Piping Operating Instructions Safety Information Vsph Boiler Sequence of Operation Integrated Boiler Control Normal Operation Status of Indicator Lights LED’SDescription of Operation Power TSTAT/CIRC LED Limit Press Switch Flame LEDDiagnostic Flash Codes LED’s FlashingIndication Remedy II. Inspection During Heating Season Care and MaintenanceGeneral Maintenance CleaningBurners Fail to OPERATE- no Heat Cause General Troubleshooting Guide For Service PersonnelBurner will not Shut OFF Cause Not Enough Heat CauseIf Replacement Parts are Needed Burner Short Cycles Cause RemedyFumes and GAS Odors Cause Remedy SLANT/FIN CORPORATION, Greenvale, N.Y Phone 516

VSPH-180, VSPH-60 specifications

Slant/Fin is a renowned name in the heating industry, renowned for its innovation, quality, and efficiency. Among its popular offerings are the VSPH-180 and VSPH-60, two highly efficient gas-fired residential boilers designed to provide reliable heating for homes.

The VSPH-180 is a high-efficiency residential boiler that delivers exceptional heating performance while being mindful of energy consumption. It operates at an impressive AFUE (Annual Fuel Utilization Efficiency) rating of up to 95%, meaning it uses 95% of the fuel burned for heating, resulting in lower energy bills and reduced environmental impact. The VSPH-180 features a durable stainless steel heat exchanger that not only contributes to its efficiency but also prolongs the boiler's lifespan.

On the other hand, the VSPH-60 is a slightly smaller but equally efficient model that is perfect for apartments or smaller homes. It also boasts a remarkable AFUE rating of up to 95%, ensuring cost-effective heating solutions. The compact design of the VSPH-60 allows for easy installation in various locations, making it a versatile choice for homeowners seeking space-saving options without compromising on performance.

One of the standout technologies in both models is the modulating gas valve, which adjusts the burner’s output to match the heating demand. This feature enhances energy efficiency by preventing the boiler from working harder than necessary, ensuring consistent temperatures and reducing wear on the unit. Furthermore, both models are equipped with a built-in electronic ignition system, eliminating the need for a pilot light and adding convenience for homeowners.

The VSPH series is designed with maintenance ease in mind. It features a user-friendly control panel that provides easy access to critical information, allowing for straightforward diagnostics and service. Regular maintenance can be performed with minimal disruption, enabling owners to keep their systems running optimally throughout the heating season.

In conclusion, the Slant/Fin VSPH-180 and VSPH-60 represent excellence in residential heating technology. With high AFUE ratings, durable construction, and advanced features, both boilers provide efficient and reliable heating solutions, ensuring comfort and energy savings for homeowners.
Top Page Image Contents