3M 7684-S-8 manual Important Notice

Page 22

3M, Scotch and Scotchlok are trademarks of 3M Company.

UniShield is a registered trademark of General Cable Technologies Corporation.

Important Notice

All statements, technical information, and recommendations related to 3M's products are based on information believed to be reliable, but the accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3M's current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in writing, by an authorized officer of 3M.

Warranty; Limited Remedy; Limited Liability.

This product will be free from defects in material and manufacture at the time of purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M's option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.

3

Electrical Markets Division

6801 River Place Blvd.

 

Austin, TX 78726-9000

 

800.245.3573

Please Recycle. Printed in USA.

Fax 800.245.0329

© 3M 2012. All Rights Reserved.

www.3M.com/electrical

78-8117-0985-2 Rev C

Image 22
Contents With High-K Stress Relief 7684-S-8 InstructionsKit Contents Instructions For Tape Shielded Cable Prepare CableInstall Ground Braid Special Note for Cloth or Paper SEMI-CON Insulation Shield Install Lug or Connector Do not Remove Core AT this TimeInstall Termination Vinyl Tape MarkerInstructions for Wire Shielded Cable Sure to allow for depth of terminal lug6 mm Constant Force Spring Trim Shield Wires This Time Counter-Clockwise Instructions for UniShield Shielded Cable Allow for depth of terminal lugRemove semi-conductive jacket to dimension shown in Figure Shield Wire ND Scotch Mastic Strip Install Lug or Connector Vinyl Tape Marker Ridge at End of Cable Tooling Index Thru 30045 One holeThru 40079 One hole Thru 40178 Two hole Conductor Size AWG & kcmil Stranded Important Notice