3M 7622-T-110, 7626-T-110, 7624-T-110, 7623-T-110, 7625-T-110 manual Environmental Top

Page 16

Correct Installation of Termination on UniShield® Shielded Cable
Vinyl Tape
Marker	Ridge at End of Cable
	Ridge at End of Cable
	Insulation Shield (Semi-Con)
Ridge at End
of High-K Tube
Semi-Con	Cable Insulation	Environmental Top
Stress Controlling Compound	Conductor	Seal
Stress Controlling Compound	Conductor
		High-K Stress
		Relief Tube

16	78-8113-5099-6 Rev E

Image 16

Contents 7626-T-110 Instructions Ieee Std. No Class 1 Termination 15 kV ClassKit Contents Kit Selection TableInstall Ground Braid Instructions for Tape Shielded CablePrepare Cable Aluminum Lug 400 750-1000 1250Rev E Install Lug or Connector Special Note for Cloth or Paper SEMI-CON Insulation ShieldInstall Termination Correct Installation of Termination on Tape Shielded CableInstructions for Wire Shielded Cable Terminal LUG6 mm Semi-Con 1st Scotch Mastic Strip 2230 Cable Jacket Cable Connector/Lug Do not Allow Solvent to Touch SEMI-CON Insulation ShieldCorrect Installation of Termination on Wire Shielded Cable Instructions for UniShield Shielded CableRemove semi-conductive jacket to dimension shown in Figure 1st Scotch Mastic Strip Constant Force Spring Shield Wires Polymers and can be recycled Environmental Top Tooling Index Thru 30045 One holeThru 40079 One hole Thru 40178 Two hole Crimping Tool-Die Sets Minimum Number Of Crimps3M Connector Number Manufacturer Conductor Size AWG & kcmil StrandedRecommended Crimping Tools Mech. Tool Die Minimum No CrimpsWarranty Limited Remedy Limited Liability Important Notice