3M 7624-T-110, 7626-T-110, 7622-T-110 Remove semi-conductive jacket to dimension shown in Figure

12.4Remove constant force spring. Bend shield wires back upon cable jacket 1-1/2" (38 mm). Cut excess shield wire and discard (Figure 17).

Depth Of Terminal Lug + Growth Allowance

9" (229 mm)

1-1/2" (38 mm)

Semi-Conductive Jacket

Fold Back Shield Wires

Figure 17

12.5 Remove semi-conductive jacket to dimension shown in Figure 18.

NOTE: To ease jacket removal, install constant force spring as shown in Figure 18 and ring-cut 80% through jacket. Remove jacket sections by pulling against constant force spring. DO NOT BELL SEMI-CON JACKET. Remove constant force spring.

NOTE: It is imperative to remove all remnants of the semi-conductive jacket, even if the semi-conductive jacket comes off as one layer. There should not be any remaining black areas, or particles, on the cable insulation layer.

		Depth Of Terminal Lug + Growth Allowance
		6" (152 mm)
1-1/2"	(38 mm)	1-1/2" (38 mm)
		Semi-Conductive Jacket
		Cut Line
		Constant Force Spring
		Fold Back Shield Wires

Figure 18

12 78-8113-5099-6 Rev E