Instructions for Wire Shielded Cable, Terminal LUG

Instructions for Wire Shielded Cable

7.0Prepare Cable

7.1Check to be sure cable size fits within kit range as shown in Table 1.

7.2Prepare cable using dimensions shown in Figure 8 and Figure 9. BE SURE TO ALLOW FOR DEPTH OF

TERMINAL LUG.

NOTE: Provide additional exposed conductor distance to account for growth during crimping of ALUMINUM lugs or connectors as follows:

Aluminum Lug	2 - 350	400 - 650	750–1000	1250 - 2000
and Connector
	1/4” (6 mm)	1/2” (13 mm)	3/4” (19 mm)	Field determined
Growth Allowance

NOTE: It is imperative to remove all remnants of the semi-con layer, even if the semi-con layer comes off as one layer. There should not be any remaining black areas, or particles, on the cable insulation layer.

Jacket Removal Length

Depth Of Terminal Lug + Growth Allowance

9" (229 mm)

3" (76 mm)

Semi-Con

Shield Wires

Cable Jacket

Figure 8

7.3Bend leading 1-1/2" (38 mm) of exposed shield wires back upon themselves to jacket edge (Figure 9).

3" (76 mm)

1-1/2" (38 mm)

Semi-Con

Shield Wires

Cable Jacket

Figure 9

78-8113-5099-6 Rev E