Samsung SHR-4080P manual Alarm

SHR-4080P USER’S MANUAL

●Quality

Recording resolution will be determined.

Choose one from Level 1(Low) to Level 8 (High). Level 8 supplies the best resolution

●Rate

Determines Frame Rate to be recorded. Frame Rate means the number of screen recorded every second.

Set to 25ips, the system records too many screens per second and play continues intermittently since recording is more detailed. This is appropriate for concentrated monitoring zone setup.

25 ips/ 12.5 ips/ 8.33 ips/ 6.25 ips/ 5 ips/ 2.5 ips/ 1 ips

Note

[Monitor Out]

You are not allowed to set up “25ips” of Rate and Video sized “Full D1” simultane- ously. The system does not support both at once.

●PreAlarm

Pre Alarm Section

Event occurred point of time

Records the situation until Alarm is issued.

Off : No recording

3sec/ 5sec/ 10sec/ 20sec/ 30sec : The recording time options before Alarm issue

●PostAlarm

Post Alarm Section

Event occurred point of time

Records the situation since Alarm is issued.

Off : No recording

3sec/ 5sec/ 10sec/ 20sec/ 30sec/1min/3min/5min/10min/20min : To this, the recording time after Alarm issue is set.

Alarm

●Sensor State

Off : Sensor does not operate.

① N.O(Normal Open) Sensor : Sensor remains open all the time and if closed, an

alarm will be issued. (A Contact)

➁N.C(Normal Close) Sensor : Sensor remains closed all the time and if open, an alarm will be issued. ( B Contact)

●Cam

Determines a camera which will synchronize with the current sensor.

The default is currently set to the sensor number. A sensor shall be synchronized with at least a camera. Multi-synchronization is possible.

Alarm

Sensor	Sensor State			Cam		Alarm-Out	Beep-Out
1	N.O			1		None	10sec
2	Off						10sec
		CHO1		CHO2		CHO3
3	Off	CHO4		CHO5		CHO6	10sec
4	Off						10sec
5	Off	CHO7		CHO8		All	10sec
6	Off		OK		Cencel		10sec
7	Off			1		None	10sec
8
	Off			0		None	10sec
						OK		Cancel

●Alarm-Out

Arranges Alarm-Out when Alarm Sensor sounds.

At this moment, this supports 5 Alarm Outs. Choose an alarm-out that you want to synchronize with the current sensor. Multi-choice is possible.

●Beep-Out

Determines Alarm-Out Duration. Alarm-Out continues for the determined duration. Off/ 3sec/ 5sec/ 10sec/ 20sec/ 30sec/ 1min/ 2min

5-19 5-20