Checking the remote controller
•Point the remote controller towards the remote controller receiver of the indoor unit.
•When you properly press the button on the remote controller, you will hear beep sound from the indoor unit and a transmit indicator() appears on the remote controller display.
Remote controller buttons
Before using the functions of the remote controller, you should set the current time. (Refer to p.14)
Remote controller display
SPi
Set the SPi function on/off.
Smart Saver
Less energy usage makes your space cool between the temperature range of 24°C~30°C.
Turbo
Operate in auto fan speed to cool quickly.
Temp + -
Increase/Decrease the temperature by 1˚C.
Auto Clean
Auto clean function – Dry inside of the indoor unit to get rid of odor.
d'light Cool
Set the d'light Cool function on/off.
Power
Turn on/off the air conditioner.
Mode
Set one of the 5 operating modes (see pages 10~11 for instructions).
Quiet
Reduce noise generated from an indoor unit during operation.
Air swing
Activate/Deactivate air flow blade movement automatically up and down.
Fan | |
| |
Adjust how much air flows through the air conditioner with the 4 different fan speeds such as Auto/Low/Medium/High.
Set the | mode on. |
On Timer
Set the On Timer on.
Off Timer
Set the Off Timer on.
Temp/Humi
•Display the room humidity level and temperature value for 5 seconds on the indoor unit display:
-Hi : High (If the relative humidity is 70% or higher)
-Sd : Standard (If the relative humidity is lower than 70%)
-For room temperature will be displayed the value.
Set/Cancel
Cancel the timer/ mode.
2ndF
Switch the function of the button on the remote controller.
Beep off
To silence the beep sound when pressing the button.
Display off
To turn off the display light
Time set
Set the current time
• When you press [2ndF] button, the indicator will be displayed on the remote controller and you can change
the functions on the remote controller as listed below.
d'light Cool Temp/Humi, Auto Clean Beep Off, good’sleep Display Off, On Timer Time Set function. If you select the function under the button while the function of the button is switched by 2ndF button,
the 2ndF function is canceled.
8