Installing the Water Line

However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice-maker to operate properly, a water pressure of 138~862 Kpa is required.

Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in 10 seconds. If the Refrigerator

is installed in an area with low water pressure (below 138Kpa), you can install a booster pump to compensate for the low pressure.

Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.

Water line installation kits are available at extra cost from your dealer.

We recommend using a water supply kit that contains copper tubing.

Connecting the water line to the Refrigerator.

There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store.

•	6.35mm compression	•	copper tubing
	nut	•	copper tubing
	nut

•	plastic tubing	•	ferrule

Refrigerator

The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.

Check the accessory list below.

Compression fitting

Compression nut

Plastic tubing (A) (Supplied)

Ferrule (Not supplied)

Copper tubing (Not supplied)

Compression nut (A) (1/4”)

(Supplied)

Compression fitting (Supplied)

Molded

end(Bulb)

Compression nut (B) (1/4”) (Not supplied)

	or	Plastic tubing (B)
	or	(Not supplied)
		(Not supplied)

Connecting to the water supply line

1.First, shut off the main water supply line and turn the ice-maker off.

2.Locate the nearest cold water drinking line.

3.After connecting the water supply with water filter, turn on water supply and Flush 3L through filter before use (flush approximately 6 minutes).

Cold Water Line

Pipe clamp

Water line installation kit

Shut off valve

12_ setting up

DA99-03404E-12.indb 12

Household water line

1.Slip the compression nut through the supplied plastic tubing(A).

2.Tighten the compression nut (A) onto the 6.35mm compression fitting.

-If you are using copper tubing, slip the compression nut (B)(not included) and ferrule (not included) on copper tubing (not included) as shown.

-If you are using plastic tubing (B), insert the molded end(Bulb) of the plastic tubing (B)into the compression fitting. Do not use without the

molded end(Bulb) of the plastic tubing (B).

3.Tighten the compression nut (B)onto the compression fitting. Do not over-tighten the compression nut (B).

4.Turn water on and check for any leakage.

Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 6.35mm of the plastic tubing to make sure you get a snug, leak-free connection.

2016. 12. 2.�� 4:33