CHECKING THAT YOUR OVEN IS OPERATING CORRECTLY
The following simple procedure enables you to check that your oven is working correctly at all times. If you are in doubt, refer to the section entitled “Troubleshooting” on the page
The oven must be plugged into an appropriate wall socket. The turntable must be in position in the oven. If a power level other than the maximum (100 % - 900 W) is used, the water takes longer to boil.
Open the oven door by pulling the handle on the right side of the door. Place a glass of water on the turntable. Close the door.
Press the Start/+30s button and set the time to 4 or 5 minutes, by pressing the Start/+30s button the appropriate number of times.
Result:
SETTING THE TIME
Your microwave oven has an inbuilt clock. When power is supplied, “88:88” and then “12:00” is automatically displayed on the display.
Please set the current time. The time can be displayed in either the
•When you first install your microwave oven
•After a power failure
Do not forget to reset the clock when you switch to and from summer and winter time.
1. Press the Clock button.
2. Press the Up or Down button to set time display type (12H
or 24H). At that time, press the Select button to set the
display type.
3.Press the Up or Down button to set the hour.
4. Press the Select button.
5.Press the Up or Down button to set the minute.
6.When the right time is displayed, press the Select button to
start the clock.
Result: The time is displayed whenever you are not using the microwave oven.
03 OVEN USE