H. Install the Log Assembly
•Base logs have been permanently mounted on the grate assembly and should not be moved. See Figure 14.5.
Figure 14.5 Base Logs
•Install “Y” log on left hand side of grate using locating pins to position. See Figure 14.6.
Figure 14.6 Placing Left Top Log
•Install right top log as shown in Figure 14.7 using locating pins to position log properly.
Figure 14.7 Placing Right Top Log
I. Firescreen
The firescreen is a protective barrier and must be at- tached.
Removing Firescreen
•Open lower access panel and pull base of screen towards you.
•The top of the screen will slide out of the screen retainers at the top of the firebox opening.
Replacing Firescreen
•Remove top grille assembly by lifting upwards and pulling towards you.
•Slide top of screen panel into top screen brackets and rotate bottom of screen to lower door latches.
•Close lower access panel and reinstall top grille.
J. Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Removing Glass Assembly
•Remove firescreen.
•Pull the four (CB4236I) or six (CB4842I) glass assembly latches out of the groove on the glass frame.
•Remove the glass panel from the appliance.
Replacing Glass Assembly
•Set the glass panel on the lower two or three glass assembly latches, ensuring the glass panel is centered in the opening.
•Pull out and latch the four/six glass assembly latches into the groove on the glass frame.
•Replace firescreen.
Latches |
(both bottom |
and top) |
Glass |
Assembly |
Figure 14.8 Fixed Glass Assembly |
30 | Heatilator • Caliber BV Series • |