Desa NATURAL GAS LOG HEATER installation manual Installing, Check GAS Type

Page 8

INSTALLING

8

NOTICE

A qualified service person must install heater. Follow all local codes.

NOTICE

State or local codes may only allow operation of this appliance in a vented configuration. Check your state or local codes.

WARNING

WARNING ICON

G 001

Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. Inspect chimney flue for damage. If damaged, operate heater with flue damper closed.

WARNING

WARNING ICON

G 001

Seal any fresh air vents or ash clean-out doors located on floor or wall of fireplace. If not, drafting may cause pilot outage or sooting. Use a heat-resistant sealant. Do not seal chimney flue damper.

WARNING

WARNING ICON

G 001

Never install the heater

•in a bedroom or bathroom

•in a recreational vehicle

•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater

•in high traffic areas

•in windy or drafty areas

CAUTION

WARNING ICON

G 001

This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities in the air (such as tobacco smoke) exist, may discolor walls.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, installing heater in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, pages 5 through 8.

CHECK GAS TYPE

Use only natural gas. If your gas supply is not natural gas, do not install heater. Call dealer where you bought heater for proper type heater.

101308

Page 7 Page 9
Image 8
Page 7 Page 9
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASContents Safety Information Safety InformationLocal Codes Unpacking Product Features Safety DeviceProduct Identification OperationProviding Adequate Ventilation AIR for CombustionVentilation Determining if You Have a Confined or Unconfined Space AIR for Combustion and VentilationDetermining AIR Flow for Heater Location Ventilation AIR AIR forCombustion Installing Check GAS TypeTo Combustible Materials LOG Sizing RequirementsAnces from floor, ceiling, and adjoining wall Minimum Wall and Ceiling Clearances see FigureAccessories, Minimum Non Combustible Material ClearancesInstalling For Vented Operation,Floor Clearances Installing Damper Clamp Accessory for Vented Operation Attaching Damper ClampInstalling Heater Base Assembly Installation Items NeededAttaching Flexible Gas Hose to Heater Gas Regulator Connecting to GAS Supply Installation Items NeededChecking GAS Connections Gas ConnectionPressure Testing Heater Gas Connections Test Pressures Equal To or Less Than 1/2 PsigInstalling Logs Installing Front LogFor Your Safety Read Before Lighting Operating HeaterThermostat-Controlled Models Only OperatingHeater Operating Heater Models Front Burner Flame Pattern Inspecting BurnersPilot Flame Pattern Logs Trouble ShootingODS/PILOT and Burners Cleaning and Mainte TROUBLE- ShootingTrouble Gas leak. See Warning Sensing Bulb OptionalPositioning Optional Positioning Thermostat Sensing Bulb For Masonry Factory-built Metal FireplaceService ServiceTechnical HintsParts Not Under Warranty Replacement PartsParts Under Warranty Accessories Valve GA5010Hood GA6050 Hood GA6052Illustrated Parts Break Down Parts List Description QTYThermostat Controlled Models Parts List 101308 101308 Warranty Information Keep this Warranty
Top Page Image Contents