Desa SF20NT installation manual Lighting Instructions, What to do if YOU Smell GAS

Page 13

OPERATING HEATER

Continued

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, donʼt try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information starting on page 12.

2.Make sure equipment shutoff valve is fully open.

3.Turn off any electric power to the appliance if service is to be performed.

4.Turn control knob clockwise to the OFF position.

5.Wait five minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information starting on page 12. If you donʼt smell gas, go to the next step.

6.Turn control knob counterclockwise to the PILOT position. Press in control knob for five (5) seconds.

7.With control knob pressed in, push down and release ignitor button. This will light pilot. The pilot is attached to the front of

burner. Note: You may be running this heater for the first time after hooking up to gas supply. If so, you may need to press in control knob for 30 seconds or more. This will allow air to bleed from the gas system. If needed, keep pressing ignitor button until pilot lights. If ignitor does not light pilot, refer to Troubleshooting, page 16 or contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 14.

8.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

Note: If pilot goes out, repeat steps 4 thru 7. Thermostat models have a safety interlock system. Wait one (1) minute before lighting pilot again.

9.Turn control knob counterclockwise to desired heating level. The main burner should light.

CAUTION: Do not try to ad- just heating levels by using the equipment shutoff valve.

Ignitor Button

Control Knob

(Actual Ignitor may vary)

 

 

F

 

F

 

O

Figure 16 - Control Knob In The OFF

Position

 

Thermocouple

Ignitor

 

Electrode

 

Pilot

 

Burner

Figure 17 - Pilot

116307-01A

www.desatech.com

13

Image 13
Contents Residential Models Garage Models What to do if YOU Smell GASTable of Contents Safety Information Local Codes Product FeaturesUnpacking Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRInstallation Items InstallationCheck GAS Type Ventilation Air From OutdoorsLocating Heater Installing Heater to WallColdest part of room Attaching to wall stud Attaching to wall anchorMark two screw locations on wall as shown in Figure Marking Screw LocationsLocate hardware packet behind left side door of heater Attaching To Wall Anchor MethodExternal Regulator With Vent Pointing Down Connecting to GAS SupplyTest Pressures In Excess Of 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Installing Refractory and Front Panel For Your Safety Read Before LightingOperating Heater Make sure control knob of heater is in the OFF positionWhat to do if YOU Smell GAS Lighting InstructionsInspecting Heater ODS/PILOT and Burner Cleaning MaintenanceBurner Pilot AIR Inlet CabinetObserved Problem Possible Cause Remedy TroubleshootingContact local propane/LP gas company Problem could be caused by Goes out when control knob is Control knob not pressedAssembly Delayed ignition of burners Manifold pressure is too lowDirty or partially clogged Clean burner see Cleaning Noise when burner is litWhen heated, vapors from Turn heater off when using Turn off air supplyService Publications Service Hints Technical ServiceWhen Gas Pressure Is Too Low Gas leak. See WarningSF30NT SF30PT SpecificationsLSF30NT, VSF30NT LSF30PT, VSF30PT Replacement Parts AccessoriesParts Central Illustrated Parts Breakdown LSF20PT Parts ListKeep this Warranty Warranty InformationModelos Modelos Para Cochera QUÉ Hacer SI Percibe Olor a GASTabla DE Contenido Información DE Seguridad Identificación DEL Producto Códigos LocalesDesempaque Características DEL ProductoCómo Procurar LA Ventilación Adecuada Aire Para Combustión VentilaciónConstrucción inusualmente sellada Espacio confinado y no confinadoAire del interior de la construcción para ventilación Aire Para VentilaciónVerifique EL Tipo DE GAS InstalaciónArtículos DE Instalación Aire del exterior para ventilaciónUbicación DEL Calentador En áreas con mucho viento oDoble en anclaje de pared como se muestra en la figura Instalación DEL Calentador EN LA ParedColocación del calentador en los tornillos de montaje Coloque el calentador en los tornillos de montajeVentila apuntando hacia abajo Conexión AL Suministro DE GASGas natural Revisión DE LAS Conexiones DE GASPropano o gas LP Repare todas las fugas inmediatamenteInstale el panel anterior y el refractario Abra la válvula de cierre del equipo consulte la figuraInstalación del panel anterior y el refractario No intente encender ningún aparato Instrucciones DE EncendidoInspección DEL Calentador Funcionamiento DELLimpieza Y Mantenimiento Inspección DELEntrada DE Aire AL Piloto DEL Quemador Como se muestra en la figuraCausa Posible Remedio Solución DE ProblemasBaja presión del gas Problema Observado Causa Posible RemedioEl termopar está dañado Presione totalmente la perilla de controlCierre el suministro de aire El problema desapareceráSe enciende o se apaga Silbante cuando el quemadorConsejos Para Servicio Servicio TécnicoCuando la presión del gas de entrada sea muy baja SF30NT EspecificacionesLSF30NT, VSF30NT Piezas DE Repuesto AccesoriosCentral DE Piezas Clasificación Ilustrada DE Piezas Lista DE Piezas Guarde Esta Garantía Información DE Garantía

SF20NT specifications

Desa SF20NT is a versatile and innovative gas-fired space heater designed for efficient heating solutions in various environments, whether in residential, commercial, or industrial settings. This model is known for its high performance, energy efficiency, and advanced technology, making it a popular choice among users seeking reliability and effectiveness in their heating needs.

One of the primary features of the Desa SF20NT is its impressive heating capacity. With a heating output of around 20,000 BTUs, it can effectively warm spaces up to 1,000 square feet, making it suitable for larger areas. This capability is enhanced by the heater's superior metal construction, ensuring durability and long-lasting performance.

In terms of technology, the Desa SF20NT incorporates a direct vent system that utilizes outside air for combustion. This feature not only increases efficiency but also enhances safety, as it minimizes the risk of hazardous fumes entering the living space. The direct vent system allows for installation flexibility; the unit can be vented horizontally through a wall or vertically through a roof, catering to different building designs.

Another standout characteristic of the Desa SF20NT is its thermostat control, which allows users to maintain a consistent temperature easily. This feature contributes to energy savings by enabling the heater to operate only when necessary, thus reducing unnecessary heating costs. Additionally, the unit includes a programmable timer, allowing users to set specific heating schedules, further optimizing energy use.

Safety is also a critical aspect of the Desa SF20NT design. It comes with built-in safety features such as a flame sensor and a safety shut-off system, ensuring that the heater operates under safe conditions at all times. The unit is designed to meet stringent safety standards, giving users peace of mind.

In summary, the Desa SF20NT is a powerful, efficient, and safe space heater that is equipped with modern features and technologies. With its high heating capacity, direct vent system, thermostat control, and safety mechanisms, it stands out as an excellent choice for anyone looking for reliable heating solutions. Whether for home or business use, the Desa SF20NT is built to provide comfort and efficiency year-round.