COUPLER “A”
|
| TAP | |
| LINE OUTLET | ||
SIDE OF | 90 degree | ||
PURIFIER |
| CAUTION | |
|
| ||
PURIFIER WATER | Insert Locking Clip After | ||
tube seated | |||
|
| ||
WATER INLET | COUPLER | Locking Clip | |
SIDE OF PURIFIER |
| ||
|
|
Replacement Instructions
1.Shut off water supply.
2.Note the Flow direction on the fi lter.
3.Insert water supply tube into the inlet side of the fi lter until the tube stop.
FLOW DIRECTION
Remove any residual matter inside the purifier. (Model with the purifier)
-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifi er.
-If water does not come out through the line, check whether the tap is open.
-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.
OUTLET SIDE | PURIFIER |
OF PURIFIER | |
WATER | WATER LINE |
|
Attach the purifier lock-clip.
-Hold the purifi er
WATER SUPPLY | PERMEAT |
INLET SIDE |
|
Note : You must also ensure that the cut is square and not at any sort of angle as this could cause a leak
4.After inserting tube, put together the clip strongly. The Clip fi x the tube.
5.Turn on the water and check for leaks. If leaks occur, repeat step 1,2,3,4. If leaks persist, discontinue use and call your supporting dealer.
6.Flush fi lter for 5 minutes before use.
14_ setting up
PURIFIER
Secure the purifier in position.
-Fix the purifi er in position, as shown in the fi gure on the right.
WATER TUBE
PURIFIER
PURIFIER
2012.8.23 11:25:45 AM |