Quadra-Fire QV-ST, QV-PIER owner manual 3Installing the Fireplace, Locating the Fireplace

3Installing the Fireplace

Step 1. Locating the Fireplace

The diagram below shows space and clearance require- ments for locating a fireplace within a room.

ÎNote: Refer to Figure 4B for dimensions and appliance locations if installing a QV-PIER-HV unit with a Catalina shelf and/or marble package.

GLASS	QV-PIER-HV-IPI	GLASS
	TOP VIEW
36"	GLASS	36"

36"

36"

GLASS

QV-ST-HV-IPI

TOP VIEW

GLASS

36"

Figure 4A. Fireplace Dimensions and Locations

ÎNote: Refer to the Catalina installation instruction included with kit for assembly and installation.

Note: This location diagram MUST be followed when in- stalling a QV-Pier-HV with a Catalina shelf/marble package since the fireplace is installed further from finished wall.

FINISHED

WALL

45 -1/4 in. (1149mm)

50-1/2 in.34-1/2 in.

7 in.

47-1/2 in.

				13/16 in.
			45-1/4 in.
	Marble sizes (inches):
	Header		26 x 8
	Side headers		.................. 45-1/2 x 8
	Legs	................................	33-1/2 x 7
Figure 4B.		Fireplace Locations/Dimensions with			Í
		Catalina Shelf/Marble Package ONLY

Clearance Requirements

The top, back, and sides of the fireplace are defined by stand-offs. The minimum clearance to a perpendicular wall extending past the face of the fireplace is one inch (25 mm). The metal ends of the fireplace may NOT be recessed into combustible construction.

Quadra-Fire • QV-PIER, QV-ST Series: HV-IPI • 2005-901 Rev. G • 2/06 13